EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC-ND 4.0

Photovoltaic module leach testing: Database development and statistical analysis

Fang Li, Sai Ravi Tatapudi, Stephanie L Shaw, Cara Libby, Bulent Bicer, GovindaSamy TamizhMani

Journal of Environmental Management · 2025

DOI: 10.1016/j.jenvman.2025.124666 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Environmental Management, 2025. Verfasst von Fang Li und 5 weiteren Autor:innen. Beteiligte Einrichtung: Photovoltaic Reliability Laboratory, Arizona State University, Mesa, AZ, USA. Electronic address: fangli3@asu.edu. Hauptthemen laut MEDLINE: Lead. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 35 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0). Gefördert von: Electric Power Research Institute, Idaho Beef Council.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This paper presents a database compiling 97 sample results based on U.S. Environmental Protection Agency (EPA) Toxicity Characteristic Leaching Procedure (TCLP) testing of 33 photovoltaic (PV) modules (1-3 samples per module) of differing designs covering 16 different manufacturers. Pieces were removed from each module following the ASTM E3325 - 21 standard practice, which uses a waterjet cutting method to extract a proportional number of pieces from four representative areas within the module laminate. Laboratory TCLP results were analyzed and categorized based on several module attributes: (i) fresh vs. field-aged modules; (ii) crystalline silicon modules with traditional back-surface field (BSF) cell technology vs. modern cell technologies, such as passivated emitter rear contact (PERC), interdigitated back contact (IBC), etc.; (iii) ribbon vs. wire interconnect technologies; (iv) glass/polymer vs. glass/glass constructions; and (v) crystalline silicon vs. cadmium telluride technologies. Results reveal only 3 of the 33 modules tested would be classified as hazardous, and that a lower probability of lead (Pb) leaching from modules manufactured using one or more modern technologies (which include modern cell technologies, wire interconnect technology, and glass/glass construction) as compared to traditional technologies. Material aging appeared to be a possible cause of increased Pb leaching concentrations in two field-aged hazardous modules compared to their fresh counterparts. The study suggests less than an 8% probability of traditional technologies' samples containing leachable Pb that exceeds the EPA Method 1311 limits when sampling using the ASTM standard practice procedure; however, the sample size was small, and expanding the database in the future is necessary to better represent the range of deployed PV technologies.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

LeadDatabases, FactualEnvironmental MonitoringUnited StatesUnited States Environmental Protection Agency

Stichwörter der Autor:innen

ASTM E3325LandfillMethod 1311PVTCLPToxicity

Substanzen

Lead

Autor:innen und Institutionen

  • Photovoltaic Reliability Laboratory, Arizona State University, Mesa, AZ, USA. Electronic address: fangli3@asu.edu.
  • Photovoltaic Reliability Laboratory, Arizona State University, Mesa, AZ, USA.
  • EPRI, Palo Alto, CA, USA.

Förderung

  • Electric Power Research Institute
  • Idaho Beef Council

Zitieren

APA

Li, F., Tatapudi, S. R., Shaw, S. L., Libby, C., Bicer, B., & TamizhMani, G. (2025). Photovoltaic module leach testing: Database development and statistical analysis. Journal of Environmental Management. https://doi.org/10.1016/j.jenvman.2025.124666

Vancouver

Li F, Tatapudi SR, Shaw SL, Libby C, Bicer B, TamizhMani G. Photovoltaic module leach testing: Database development and statistical analysis. Journal of Environmental Management. 2025. doi:10.1016/j.jenvman.2025.124666

BibTeX
@article{Li2025,
  author = {Li, Fang and Tatapudi, Sai Ravi and Shaw, Stephanie L and Libby, Cara and Bicer, Bulent and TamizhMani, GovindaSamy},
  title = {Photovoltaic module leach testing: Database development and statistical analysis},
  journal = {Journal of Environmental Management},
  year = {2025},
  doi = {10.1016/j.jenvman.2025.124666}
}
Kostenlos starten →