EUVIMEDEUVIMED entdecken
Crossref

Impact of quantification method on microfiber assessment – A comparative analysis between mass and count based methods

R Rathinamoorthy, S Raja Balasaraswathi

Journal of Environmental Management · 2023

DOI: 10.1016/j.jenvman.2023.119040 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Environmental Management, 2023. Verfasst von R Rathinamoorthy und 1 weiteren Autor:innen. Beteiligte Einrichtung: Department of Fashion Technology, PSG College of Technology, Coimbatore, 641004, India. Electronic address: r.rathinamoorthy@gmail.com. Hauptthemen laut MEDLINE: Laundering, Water Pollutants, Chemical. Die Arbeit wurde bisher 7-mal zitiert (Crossref) und nennt 46 Literaturangaben.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Microfiber from textiles is one of the new anthropogenic pollutants which attracted a wide range of researchers. Domestic laundry, being the most common cause of microfiber release from textiles, is widely studied. Studies exhibit a broad range of quantities of microfibers owing to the distinct quantification methodologies employed due to their convenience and resource availability. Out of several such estimation processes, reporting microfiber quantity in numbers or mass (mg or g) is quite common with respect to the unit area or weight of the textile used. However, results reported by different literature vary significantly. Hence, this study aims to analyze the microfiber release from knitted polyester fabric using count- and mass-based methods. Four different fabrics were used for this study with three different counting processes from literature along with direct weight difference estimation. The results of the direct counting method showed that the average microfiber release of selected fabrics is 13.28-33.16 microfibers per sq.cm, whereas, the direct weight estimation showed an average weight of 0.0664 ± 0.0289 mg/sq.cm. The subsequent conversion showed a release of 887.89 ± 633.49 microfibers/sq.cm of the fabric. Further, the microfiber mass was also estimated using the number of microfiber count and found that a sq.cm of fabric releases up to 0.0010-0.0024 mg of microfibers. While comparing the results, the weight-based estimation showed a significantly higher microfiber release (41.3-42.9 times) than the direct counting method. The deposition of surfactants in detergents, contaminants from the water, atmospheric contaminants, and finishes released from the fabric can be the sources of additional weights noted in the direct mass estimation. As the weight-based method is quite simple and the fastest way to quantify the microfibers, future studies must focus on this area to reduce the error percentage in quantification.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

LaunderingWater Pollutants, ChemicalPlasticsTextilesPolyesters

Stichwörter der Autor:innen

Count-based methodsKnitted fabricMicrofiberPolyesterQuantification methodsWeight-based method

Substanzen

PlasticsPolyestersWater Pollutants, Chemical

Autor:innen und Institutionen

  • Department of Fashion Technology, PSG College of Technology, Coimbatore, 641004, India. Electronic address: r.rathinamoorthy@gmail.com.
  • Department of Fashion Technology, PSG College of Technology, Coimbatore, 641004, India.

Zitieren

APA

Rathinamoorthy, R., & Raja Balasaraswathi, S. (2023). Impact of quantification method on microfiber assessment – A comparative analysis between mass and count based methods. Journal of Environmental Management. https://doi.org/10.1016/j.jenvman.2023.119040

Vancouver

Rathinamoorthy R, Raja Balasaraswathi S. Impact of quantification method on microfiber assessment – A comparative analysis between mass and count based methods. Journal of Environmental Management. 2023. doi:10.1016/j.jenvman.2023.119040

BibTeX
@article{Rathinamoorthy2023,
  author = {Rathinamoorthy, R and Raja Balasaraswathi, S},
  title = {Impact of quantification method on microfiber assessment – A comparative analysis between mass and count based methods},
  journal = {Journal of Environmental Management},
  year = {2023},
  doi = {10.1016/j.jenvman.2023.119040}
}
Kostenlos starten →