EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC-ND 4.0

Fluorotelomer alcohol (FTOH) emission rates from new and old rain jackets to air determined by iodide high-resolution chemical ionization mass spectrometry

Clara M.A. Eichler, Michael J. Davern, Jason D. Surratt, Glenn C. Morrison, Barbara J. Turpin

Indoor Environments · 2024-12 · 1 (4) · 100055

DOI: 10.1016/j.indenv.2024.100055 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Indoor Environments, 2024-12. Verfasst von Clara M.A. Eichler und 4 weiteren Autor:innen. Die Arbeit wurde bisher 8-mal zitiert (Crossref) und nennt 57 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0). Gefördert von: United States Environmental Protection Agency, National Science Foundation Graduate Research Fellowship Program, Alfred P Sloan Foundation.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Per- and polyfluoroalkyl substances (PFAS), which include fluorotelomer alcohols (FTOHs), are synthetic chemicals used in consumer products because of their water-, stain-, and grease-repellent properties; thus, PFAS are commonly found in functional clothing such as rain jackets. To date, emissions of PFAS from products to indoor air have not been well characterized, although many PFAS-containing products are used and stored indoors. We used a test chamber connected to a high-resolution time-of-flight chemical ionization mass spectrometer equipped with iodide as a reagent ion (I-HR-ToF-CIMS) to measure emission rates for four FTOHs from 10 rain jackets and one backpack cover. The materials were categorized as old/used, new, or “PFAS-free”, and they were tested under two different scenarios, i.e., immediately out of package and after airing out. We observed real-time FTOH emissions from all materials. Under the out-of-package scenario, emissions of 6:2, 8:2 and 10:2 FTOH showed characteristics that indicate mass transfer is limited by internal diffusion, with a high initial peak followed by a lower steady-state emission rate. Peak emission rates correlated well with material-phase concentrations determined by an offline extractive gas chromatography-mass spectrometry (GC-MS) method. Our results further suggest that the old, used jackets had, on average, higher peak emission rates and higher material-phase concentrations than the new jackets, largely driven by 8:2 FTOH. “PFAS-free” materials had the overall lowest emission rates and material-phase concentrations. After airing out, emission rates were on average an order of magnitude lower than peak emission rates. Our findings emphasize the importance of considering consumer products like rain jackets as sources of indoor exposure to PFAS.

Förderung

  • United States Environmental Protection Agency
  • National Science Foundation Graduate Research Fellowship Program
  • Alfred P Sloan Foundation
  • North Carolina General Assembly
  • University of North Carolina at Chapel Hill
  • ASM International
  • National Science Foundation

Zitieren

APA

Eichler, C. M., Davern, M. J., Surratt, J. D., Morrison, G. C., & Turpin, B. J. (2024). Fluorotelomer alcohol (FTOH) emission rates from new and old rain jackets to air determined by iodide high-resolution chemical ionization mass spectrometry. Indoor Environments, 1(4), 100055. https://doi.org/10.1016/j.indenv.2024.100055

Vancouver

Eichler CM, Davern MJ, Surratt JD, Morrison GC, Turpin BJ. Fluorotelomer alcohol (FTOH) emission rates from new and old rain jackets to air determined by iodide high-resolution chemical ionization mass spectrometry. Indoor Environments. 2024;1(4):100055. doi:10.1016/j.indenv.2024.100055

BibTeX
@article{Eichler2024,
  author = {Eichler, Clara M.A. and Davern, Michael J. and Surratt, Jason D. and Morrison, Glenn C. and Turpin, Barbara J.},
  title = {Fluorotelomer alcohol (FTOH) emission rates from new and old rain jackets to air determined by iodide high-resolution chemical ionization mass spectrometry},
  journal = {Indoor Environments},
  year = {2024},
  volume = {1},
  number = {4},
  pages = {100055},
  doi = {10.1016/j.indenv.2024.100055}
}
Kostenlos starten →