Experimental investigation of hot steam temperature effects on physicochemical properties and mineralization efficiency in steel Slag-CO2 systems
Environmental Research · 2025
DOI: 10.1016/j.envres.2025.121727 ↗Kurz gefasst
Fachartikel in der Zeitschrift Environmental Research, 2025. Verfasst von Binwei Xia und 2 weiteren Autor:innen. Beteiligte Einrichtung: State Key Laboratory of Coal Mine Disaster Dynamics and Control, Chongqing University, Chongqing, 400030, China; National & Local Joint Engineering L…. Hauptthemen laut MEDLINE: Steel, Steam, Hot Temperature, Carbon Dioxide. Die Arbeit wurde bisher 7-mal zitiert (Crossref) und nennt 53 Literaturangaben. Gefördert von: National Natural Science Foundation of China.
Abstract (Originalsprache)
In the face of intensifying global warming, carbon capture, utilization, and storage (CCUS) technologies are increasingly recognized as critical pathways toward achieving carbon neutrality. Although alkaline steel slag exhibits significant carbon sequestration potential, traditional mineralization methods are limited by low mass transfer efficiency and rapid efficiency decay caused by pore blockage and active surface coverage. To address these limitations, this study proposed an innovative approach leveraging steam-mediated activation to restructure the physicochemical properties of steel slag, thereby overcoming conventional barriers. Using a custom-designed hot steam-CO2 mineralization reactor, we systematically investigated the advantages of hot steam activation over conventional wet mineralization. Furthermore, we elucidated the effects of HS temperature on steel slag-CO2 mineralization efficiency and its underlying mechanisms. Results showed that the hydrated steel slag treated with hot steam exhibits a 2.4-fold increase in specific surface area and a 1.8-fold enhancement in porosity compared to conventional wet processing. This significant optimization of the mineralization conditions leads to an improvement in mineralization efficiency, reaching 22.48 %, which is four times higher than that achieved by conventional wet methods. With increasing hot steam temperature, mineralization efficiency showed significant enhancement, rising from 9.2 % at 100 °C to a peak of 35.14 % at 220 °C. The mineralization product CaCO3 exhibited a dual effect: filling micropores to reduce porosity for pores 3.5 nm. The rapid generation of mesopores and macropores further drove the overall porosity increase. As HS temperature rose, the surface content of CaCO3 and C-S-H in MSS increased significantly. The pore-forming effect of CaCO3 stacking resulted in higher porosity, reaching 9.2 and 6.5 times the porosity and specific surface area of RSS at 220 °C, respectively.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Stichwörter der Autor:innen
Substanzen
Autor:innen und Institutionen
- State Key Laboratory of Coal Mine Disaster Dynamics and Control, Chongqing University, Chongqing, 400030, China; National & Local Joint Engineering Laboratory of Gas Drainage in Complex Coal Seam, Chongqing University,…
Förderung
- National Natural Science Foundation of China
Zitieren
APA
Xia, B., Liu, Z., & Peng, J. (2025). Experimental investigation of hot steam temperature effects on physicochemical properties and mineralization efficiency in steel Slag-CO2 systems. Environmental Research. https://doi.org/10.1016/j.envres.2025.121727
Vancouver
Xia B, Liu Z, Peng J. Experimental investigation of hot steam temperature effects on physicochemical properties and mineralization efficiency in steel Slag-CO2 systems. Environmental Research. 2025. doi:10.1016/j.envres.2025.121727
BibTeX
@article{Xia2025,
author = {Xia, Binwei and Liu, Zhiruo and Peng, Jiansong},
title = {Experimental investigation of hot steam temperature effects on physicochemical properties and mineralization efficiency in steel Slag-CO2 systems},
journal = {Environmental Research},
year = {2025},
doi = {10.1016/j.envres.2025.121727}
}
EUVIMED