Recovery of energy and carbon fibre from wind turbine blades waste (carbon fibre/unsaturated polyester resin) using pyrolysis process and its life-cycle assessment
Environmental Research · 2024-03 · 245 · 118016
DOI: 10.1016/j.envres.2023.118016 ↗Kurz gefasst
Fachartikel in der Zeitschrift Environmental Research, 2024-03. Verfasst von Samy Yousef und 4 weiteren Autor:innen. Beteiligte Einrichtung: Department of Production Engineering, Faculty of Mechanical Engineering and Design, Kaunas University of Technology, LT-51424 Kaunas, Lithuania. Elec…. Hauptthemen laut MEDLINE: Pyrolysis, Ecosystem. Die Arbeit wurde bisher 69-mal zitiert (Crossref) und nennt 69 Literaturangaben. Gefördert von: Lietuvos Mokslo Taryba.
Abstract (Originalsprache)
Recovery of carbon fibres and resin from wind turbine blade waste (WTB) composed of carbon fibres (CF)-reinforced unsaturated polyester resin (UPR) has been environmentally challenging due to its complex structure that is not biodegradable and that is rich in highly toxic styrene (main component of UPR). Within this framework, this paper aims to liberate CF and UPR from WTB using a pyrolysis process. The treatment was performed on commercial WTB (CF/UPR) up to 600 °C using a 250 g reactor. The UPR fraction was decomposed into liquid and gaseous phases, while CF remained as a residue. The composition of gaseous phase was monitored during the entire treatment using a digital gas analyser, while gas chromatography-mass spectrometry (GC-MS) was used to characterize the collected liquid phase. CF fraction was collected and exposed to additional oxidation process after treatment at 450 °C for purification propose, then it was analysed using FTIR and SEM-EDX. Finally, the life cycle assessment (LCA) of the CF/UPR pyrolysis was studied using SimaPro software and the results were compared with landfill disposal practices. The pyrolysis results manifested that 500 °C was sufficient for UPR decomposition into styrene-rich oil and gaseous products with yields of 15.23 wt% and 6.83 wt%, respectively, accompanied by 77.93 wt% solid residue including CF. The LCA results showed that pyrolysis with oxidation process has high environmental potential in WTB recycling with significant reduction in several impact categories compared to landfill. However, the pyrolysis scenario revealed several additional environmental burdens related to ecosystems, acidification, Ozone formation, and fine particulate matter formation that must be overcome before upscaling.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Stichwörter der Autor:innen
Substanzen
Autor:innen und Institutionen
- Department of Production Engineering, Faculty of Mechanical Engineering and Design, Kaunas University of Technology, LT-51424 Kaunas, Lithuania. Electronic address: ahmed.saed@ktu.lt.
- Lithuanian Energy Institute, Laboratory of Combustion Processes, Breslaujos 3, LT-44403 Kaunas, Lithuania. Electronic address: justas.eimontas@lei.lt.
- Department of Environmental Technology, Faculty of Chemical Technology, Kaunas University of Technology, LT-50254 Kaunas, Lithuania.
- Lithuanian Energy Institute, Laboratory of Combustion Processes, Breslaujos 3, LT-44403 Kaunas, Lithuania.
Förderung
- Lietuvos Mokslo Taryba
Zitieren
APA
Yousef, S., Eimontas, J., Stasiulaitiene, I., Zakarauskas, K., & Striūgas, N. (2024). Recovery of energy and carbon fibre from wind turbine blades waste (carbon fibre/unsaturated polyester resin) using pyrolysis process and its life-cycle assessment. Environmental Research, 245, 118016. https://doi.org/10.1016/j.envres.2023.118016
Vancouver
Yousef S, Eimontas J, Stasiulaitiene I, Zakarauskas K, Striūgas N. Recovery of energy and carbon fibre from wind turbine blades waste (carbon fibre/unsaturated polyester resin) using pyrolysis process and its life-cycle assessment. Environmental Research. 2024;245:118016. doi:10.1016/j.envres.2023.118016
BibTeX
@article{Yousef2024,
author = {Yousef, Samy and Eimontas, Justas and Stasiulaitiene, Inga and Zakarauskas, Kęstutis and Striūgas, Nerijus},
title = {Recovery of energy and carbon fibre from wind turbine blades waste (carbon fibre/unsaturated polyester resin) using pyrolysis process and its life-cycle assessment},
journal = {Environmental Research},
year = {2024},
volume = {245},
pages = {118016},
doi = {10.1016/j.envres.2023.118016}
}
EUVIMED