EUVIMEDEUVIMED entdecken
Crossref

New trends in modelling of breakthrough curves to remove pollutants using adsorption on advanced monoliths geometries

Saul O Gutierrez-Reyna, E C Herrera-Hernández, Carlos G Aguilar-Madera, M Victoria López-Ramón, Raul Ocampo-Perez, Adriana Parra-Marfil, Elias Garcia-Hernandez, Esther Bailon-Garcia

Environmental Research · 2024-02 · 243 · 117871

DOI: 10.1016/j.envres.2023.117871 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Environmental Research, 2024-02. Verfasst von Saul O Gutierrez-Reyna und 7 weiteren Autor:innen. Beteiligte Einrichtung: Centro de Investigación y Estudios de Posgrado, Facultad de Ciencias Químicas, Universidad Autónoma de San Luis Potosí, San Luis Potosí, 78260, Mexic…. Hauptthemen laut MEDLINE: Environmental Pollutants, Water Pollutants, Chemical, Water Purification. Die Arbeit wurde bisher 16-mal zitiert (Crossref) und nennt 16 Literaturangaben. Gefördert von: Consejo Nacional de Ciencia y Tecnología.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This work proposes a rigorous mathematical model capable of reproducing the adsorption process in dynamic regime on advanced monoliths geometries. For this, four bed geometries with axisymmetric distribution of channels and similar solid mass were proposed. In each geometry a different distribution of channels was suggested, maintaining constant the bed dimensions of 15 cm high and 5 cm radius. The mathematical modeling includes mass and momentum transfer phenomena, and it was solved with the COMSOL Multiphysics software using mass transfer parameters published in the literature. The overall performance of the column was evaluated in terms of breakthrough (CA/CA0 = 0.1) and saturation times (CA/CA0 = 0.9). The mass and velocity distributions obtained from the proposed model show good physical consistency with what is expected in real systems. In addition, the model proved to be easy to solve given the short convergence times required (2-4 h). Modifications were made to the bed geometry to achieve a better use of the adsorbent material which reached up to 80%. The proposed bed geometries allow obtaining different mixing distributions, in such a way that inside the bed a thinning of the boundary layer is caused, thus reducing diffusive effects at the adsorbent solid-fluid interface, given dissipation rates of about 323 × 10-11 m2/s3. The bed geometry composed of intersecting rings deployed the best performance in terms of usage of the material adsorbent, and acceptable hydrodynamical behavior inside the channels (maximum fluid velocity = 35.4 × 10-5 m/s and drop pressure = 0.19 Pa). Based on these results, it was found that it is possible to reduce diffusional effects and delimit the mass transfer zone inside the monoliths, thus increasing the efficiency of adsorbent fixed beds.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

Environmental PollutantsWater Pollutants, ChemicalWater PurificationAdsorptionModels, TheoreticalMathematicsDiffusion

Stichwörter der Autor:innen

3D-printed monolithsAdsorption modellingBreakthrough curvesFixed bedMass transfer

Substanzen

Environmental PollutantsWater Pollutants, Chemical

Autor:innen und Institutionen

  • Centro de Investigación y Estudios de Posgrado, Facultad de Ciencias Químicas, Universidad Autónoma de San Luis Potosí, San Luis Potosí, 78260, Mexico.
  • Universidad Autónoma de Nuevo León, Facultad de Ciencias de la Tierra, Carretera a Cerro Prieto Km 8, Ex-Hacienda de Guadalupe, 67700, Linares, Mexico.
  • Departamento de Química Inorgánica y Orgánica, Facultad de Ciencias Experimentales, Universidad de Jaén, Jaén, 23071, Spain.
  • Centro de Investigación y Estudios de Posgrado, Facultad de Ciencias Químicas, Universidad Autónoma de San Luis Potosí, San Luis Potosí, 78260, Mexico. Electronic address: raul.ocampo@uaslp.mx.
  • Centro de Investigación y Estudios de Posgrado, Facultad de Ciencias Químicas, Universidad Autónoma de San Luis Potosí, San Luis Potosí, 78260, Mexico; Grupo de Investigación en Materiales del Carbón, Facultad de Cienci…
  • Grupo de Investigación en Materiales del Carbón, Facultad de Ciencias, Universidad de Granada, Campus Fuente Nueva s/n., 18071, Granada, Spain.

Förderung

  • Consejo Nacional de Ciencia y Tecnología

Zitieren

APA

Gutierrez-Reyna, S. O., Herrera-Hernández, E. C., Aguilar-Madera, C. G., López-Ramón, M. V., Ocampo-Perez, R., Parra-Marfil, A., Garcia-Hernandez, E., & Bailon-Garcia, E. (2024). New trends in modelling of breakthrough curves to remove pollutants using adsorption on advanced monoliths geometries. Environmental Research, 243, 117871. https://doi.org/10.1016/j.envres.2023.117871

Vancouver

Gutierrez-Reyna SO, Herrera-Hernández EC, Aguilar-Madera CG, López-Ramón MV, Ocampo-Perez R, Parra-Marfil A, et al. New trends in modelling of breakthrough curves to remove pollutants using adsorption on advanced monoliths geometries. Environmental Research. 2024;243:117871. doi:10.1016/j.envres.2023.117871

BibTeX
@article{GutierrezReyna2024,
  author = {Gutierrez-Reyna, Saul O and Herrera-Hernández, E C and Aguilar-Madera, Carlos G and López-Ramón, M Victoria and Ocampo-Perez, Raul and Parra-Marfil, Adriana and Garcia-Hernandez, Elias and Bailon-Garcia, Esther},
  title = {New trends in modelling of breakthrough curves to remove pollutants using adsorption on advanced monoliths geometries},
  journal = {Environmental Research},
  year = {2024},
  volume = {243},
  pages = {117871},
  doi = {10.1016/j.envres.2023.117871}
}
Kostenlos starten →