Characterization of microplastics from antifouling coatings released under controlled conditions with an automated SEM-EDX particle analysis method
Environmental Pollution · 2025
DOI: 10.1016/j.envpol.2025.127251 ↗Kurz gefasst
Fachartikel in der Zeitschrift Environmental Pollution, 2025. Verfasst von Matthias Bork und 3 weiteren Autor:innen. Beteiligte Einrichtung: CoaST, Department of Chemical and Biochemical Engineering, Technical University of Denmark, DTU, Building 229, Kongens Lyngby, 2800, Denmark. Electro…. Hauptthemen laut MEDLINE: Microplastics, Water Pollutants, Chemical. Die Arbeit wurde bisher 10-mal zitiert (Crossref) und nennt 39 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Hempel Fonden, Council on Ocean Affairs Science and Technology, California State University.
Abstract (Originalsprache)
A significant portion of microplastics in the marine environment originate from antifouling coatings. However, knowledge about release pathways and rates is limited. One such pathway is particle release from ship hull coatings during sailing. This study demonstrates the release of microplastic particles from a typical commercial antifouling coating in simulated low-speed sailing conditions. The self-polishing antifouling yacht coating was exposed to controlled low-speed sailing conditions in artificial seawater. The particle content of the artificial seawater was monitored throughout an automated particle analysis protocol using scanning electron microscopy and energy dispersive X-ray spectroscopy (SEM-EDX). Particle counts, sizes and chemistries were recorded. Over the duration of the exposure, the total particle volume release increased with time. Particle release behaviour can be correlated to the polishing behaviour of antifouling coatings. The equivalent diameter of the majority of the particles was 1-5 μm. The particles were mainly composed of carbon (around 58%wt.), oxygen (around 32%wt.), copper (0-8%wt.), and zinc (0-2%wt.). Carbon and part of the oxygen can be ascribed to the polymeric binder in the coating. Copper and zinc, on the other hand, can be attributed to the known biocidal pigments in the coating. This study improves our understanding of particle release from antifouling coatings.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Stichwörter der Autor:innen
Substanzen
Autor:innen und Institutionen
- CoaST, Department of Chemical and Biochemical Engineering, Technical University of Denmark, DTU, Building 229, Kongens Lyngby, 2800, Denmark. Electronic address: merbo@kt.dtu.dk.
- CoaST, Department of Chemical and Biochemical Engineering, Technical University of Denmark, DTU, Building 229, Kongens Lyngby, 2800, Denmark.
Förderung
- Hempel Fonden
- Council on Ocean Affairs Science and Technology, California State University
Zitieren
APA
Bork, M., Kiil, S., Gostin, P. F., & Dam-Johansen, K. (2025). Characterization of microplastics from antifouling coatings released under controlled conditions with an automated SEM-EDX particle analysis method. Environmental Pollution. https://doi.org/10.1016/j.envpol.2025.127251
Vancouver
Bork M, Kiil S, Gostin PF, Dam-Johansen K. Characterization of microplastics from antifouling coatings released under controlled conditions with an automated SEM-EDX particle analysis method. Environmental Pollution. 2025. doi:10.1016/j.envpol.2025.127251
BibTeX
@article{Bork2025,
author = {Bork, Matthias and Kiil, Søren and Gostin, Petre-Flaviu and Dam-Johansen, Kim},
title = {Characterization of microplastics from antifouling coatings released under controlled conditions with an automated SEM-EDX particle analysis method},
journal = {Environmental Pollution},
year = {2025},
doi = {10.1016/j.envpol.2025.127251}
}
EUVIMED