Characteristics of particulate matter from asphalt pavement and tire of a moving bus through driving tests in city road and proving ground
Environmental Pollution · 2024
DOI: 10.1016/j.envpol.2024.123336 ↗Kurz gefasst
Fachartikel in der Zeitschrift Environmental Pollution, 2024. Verfasst von Eunji Chae und 4 weiteren Autor:innen. Beteiligte Einrichtung: Department of Chemistry, Sejong University, 209 Neungdong-ro, Gwangjin-gu, Seoul, 05006, Republic of Korea. Hauptthemen laut MEDLINE: Particulate Matter, Air Pollutants. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 48 Literaturangaben. Gefördert von: Korea Ministry of Trade Industry and Energy.
Abstract (Originalsprache)
Non-exhaust PM emissions from vehicles in real road have been conducted, but heavy vehicles have rarely been tested. In this study, PM2.5 and PM10 samples were directly collected from a tire of a moving bus and the composition was analyzed to investigate the sources of PM emissions. Driving tests were conducted at a proving ground (PG) and a city road (CR). PM2.5 emissions considerably increased when the lateral force of the tire increased and the vehicle accelerated. The PM emission rate was higher in the PG test than in the CR test because of the harsher driving conditions at PG. The emission rates of PM10 in the PG and CR tests were higher than those of PM2.5 by approximately 6 and 11 times, respectively. In the PG and CR tests, the proportions of tire wear particles (TWPs) were 4.9% and 2.1% in the PM2.5 samples, and 6.8% and 8.2% in the PM10 samples, respectively. Furthermore, TWPs with PM (TWPPM) were generated by other sources: secondary production of TWPPM by fragmentation of TWPs and resuspension of TWPPM on the road. The contributions of other sources to TWP2.5 generation were at least 6% and 57% in the PG and CR tests, respectively, whereas that to TWP10 generation was at least 3.5% in the CR test. Iron derived from brake abrasion and mineral particles was observed in the PM samples, and the Fe concentrations were higher in the PM10 samples than in the PM2.5 samples by over 9 and 18 times for the PG and CR tests, respectively. Sulfur sources, such as TWPs, exhaust gas, and bitumen, were observed in the PM samples. Based on our findings, we recommend that road wear particles should be removed from roads to reduce PM emissions upon driving.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Stichwörter der Autor:innen
Substanzen
Autor:innen und Institutionen
- Department of Chemistry, Sejong University, 209 Neungdong-ro, Gwangjin-gu, Seoul, 05006, Republic of Korea.
- Chassis & Materials Research Laboratory, Korea Automotive Technology Institute, 303 Pungse-ro, Pungse-myun, Dongnam-gu, Chonan-si, Chungnam, 31214, Republic of Korea.
- Department of Chemistry, Sejong University, 209 Neungdong-ro, Gwangjin-gu, Seoul, 05006, Republic of Korea. Electronic address: sschoi@sejong.ac.kr.
Förderung
- Korea Ministry of Trade Industry and Energy
Zitieren
APA
Chae, E., Bae, S. H., Lee, S. W., Yun, J. H., & Choi, S. S. (2024). Characteristics of particulate matter from asphalt pavement and tire of a moving bus through driving tests in city road and proving ground. Environmental Pollution. https://doi.org/10.1016/j.envpol.2024.123336
Vancouver
Chae E, Bae SH, Lee SW, Yun JH, Choi SS. Characteristics of particulate matter from asphalt pavement and tire of a moving bus through driving tests in city road and proving ground. Environmental Pollution. 2024. doi:10.1016/j.envpol.2024.123336
BibTeX
@article{Chae2024,
author = {Chae, Eunji and Bae, Seok-Hu and Lee, Seung-Won and Yun, Ju-Ho and Choi, Sung-Seen},
title = {Characteristics of particulate matter from asphalt pavement and tire of a moving bus through driving tests in city road and proving ground},
journal = {Environmental Pollution},
year = {2024},
doi = {10.1016/j.envpol.2024.123336}
}
EUVIMED