Waste biomass derived highly-porous carbon material for toxic metal removal: Optimisation, mechanisms and environmental implications
Chemosphere · 2024
DOI: 10.1016/j.chemosphere.2023.140684 ↗Kurz gefasst
Fachartikel in der Zeitschrift Chemosphere, 2024. Verfasst von Marina Radenković und 6 weiteren Autor:innen. Beteiligte Einrichtung: VINCA Institute of Nuclear Sciences-National Institute of the Republic of Serbia, University of Belgrade, P.O. Box 522, 11351, Belgrade, Serbia. Hauptthemen laut MEDLINE: Copper, Water Pollutants, Chemical. Die Arbeit wurde bisher 22-mal zitiert (Crossref) und nennt 68 Literaturangaben. Gefördert von: Hrvatska Zaklada za Znanost, Ministarstvo Prosvete, Nauke i Tehnološkog Razvoja, The Royal Society.
Abstract (Originalsprache)
Toxic elements, lead, and copper are often found in wastewater discharged from industries such as mining. The discharge of untreated effluent poses severe environmental challenges and sorption methods using agricultural waste materials are proposed as an efficient and cost-effective solution. For this research, activated sunflower material (ASM) was prepared from abundantly available agricultural sunflower waste residues and utilised to remove Pb2+ and Cu2+ ions from an aqueous medium. To begin, we examine variables that may have an impact on the adsorption process, such as pH, contact time, adsorbent dose, and initial concentration using Box-Behnken Design (BBD) to find optimal conditions. Maximum removal efficiency was found at a pH of 5, contact time of 180 min, and initial concentration of 50 mg/L for Pb2+ and 150 mg/L for Cu2+. Additionally, adsorbent dose differed by element, for Cu2+ it was 200 mg, whilst for Pb2+ it was 124 mg. Features of activated carbon such as morphology, elemental composition, textural properties, and surface functionalities were characterised using SEM-EDS, BET, FTIR, and XPS. The adsorption equilibrium data were analysed by Langmuir, Freundlich, and Dubinin-Radushkevich isotherm models. It was found that the obtained results for Pb2+ adsorption were better described with the Freundlich isotherm model. Maximum adsorption capacities for Pb2+ and Cu2+ were 91.8 mg/g and 20.5 mg/g, respectively. Furthermore, kinetic studies confirmed that the adsorption process followed a pseudo-first-order kinetic model for Pb2+, but for Cu2+ all applied kinetic models fitted experimental data with the same values of the correlation coefficient (R2 = 0.99). After comprehensive analysis using the methods mentioned above, ASM was tested for the removal of Cu2+ from mining wastewater sample, and the obtained removal efficiency was 98.6% ± 2.0%. The results of desorption experiments conducted, confirm that ASM has good potential to be reused for the purpose of removing Cu2+ from wastewater.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Stichwörter der Autor:innen
Substanzen
Autor:innen und Institutionen
- VINCA Institute of Nuclear Sciences-National Institute of the Republic of Serbia, University of Belgrade, P.O. Box 522, 11351, Belgrade, Serbia.
- Environmental Research Institute, UHI North Highland, University of the Highlands and Islands, Thurso, Scotland, KW14 7JD, UK; Department of Environmental Engineering and Occupational Safety and Health, Faculty of Techn…
- Institute of Physics, Bijenička cesta 46, 10000, Zagreb, Croatia.
- VINCA Institute of Nuclear Sciences-National Institute of the Republic of Serbia, University of Belgrade, P.O. Box 522, 11351, Belgrade, Serbia. Electronic address: sanjaz@vin.bg.ac.rs.
Förderung
- Hrvatska Zaklada za Znanost
- Ministarstvo Prosvete, Nauke i Tehnološkog Razvoja
- The Royal Society
- Royal Society of Chemistry
Zitieren
APA
Radenković, M., Petrović, J., Pap, S., Kalijadis, A., Momčilović, M., Krstulović, N., & Živković, S. (2024). Waste biomass derived highly-porous carbon material for toxic metal removal: Optimisation, mechanisms and environmental implications. Chemosphere. https://doi.org/10.1016/j.chemosphere.2023.140684
Vancouver
Radenković M, Petrović J, Pap S, Kalijadis A, Momčilović M, Krstulović N, et al. Waste biomass derived highly-porous carbon material for toxic metal removal: Optimisation, mechanisms and environmental implications. Chemosphere. 2024. doi:10.1016/j.chemosphere.2023.140684
BibTeX
@article{Radenkovi2024,
author = {Radenković, Marina and Petrović, Jelena and Pap, Sabolc and Kalijadis, Ana and Momčilović, Miloš and Krstulović, Nikša and Živković, Sanja},
title = {Waste biomass derived highly-porous carbon material for toxic metal removal: Optimisation, mechanisms and environmental implications},
journal = {Chemosphere},
year = {2024},
doi = {10.1016/j.chemosphere.2023.140684}
}
EUVIMED