Aptamer-molecularly imprinted polymer sensors for the detection of bacteria in water
Biosensors and Bioelectronics · 2025-03 · 272 · 117136
DOI: 10.1016/j.bios.2025.117136 ↗Kurz gefasst
Fachartikel in der Zeitschrift Biosensors and Bioelectronics, 2025-03. Verfasst von Meltem Agar und 3 weiteren Autor:innen. Beteiligte Einrichtung: Department of Electronic and Electrical Engineering, University of Bath, Bath, BA2 7AY, United Kingdom; Centre for Bioengineering & Biomedical Techno…. Hauptthemen laut MEDLINE: Aptamers, Nucleotide, Biosensing Techniques, Staphylococcus aureus, Molecularly Imprinted Polymers. Die Arbeit wurde bisher 68-mal zitiert (Crossref) und nennt 46 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
Bacteria pose a significant threat to human health as they can cause diseases and outbreaks; therefore rapid, easy, and specific detection of bacteria in a short time is crucial. Various methods such as polymerase chain reaction and enzyme-linked immunosorbent assay have been developed for bacteria detection. However, most of these methods require sample preparation, trained personnel, and 2-4 days for identification. In this study, an electrochemical sensor has been developed in which a molecularly imprinted polymer (MIP) and aptamer were used together as a bioreceptor for the multiplexed detection of Staphylococcus aureus and Escherichia coli. Non-Faradaic electrochemical impedance spectroscopy (EIS) was employed to assess bacterial detection. Sensor performance was assessed in buffer solution, deionized water and spiked tap water. Aptamer-molecularly imprinted polymer (Apta-MIP) based electrochemical sensors demonstrate high sensitivity and selectivity for the detection of S. aureus and E. coli, with limits of detection of 4 CFU/mL and 2 CFU/mL, respectively. Additionally, these sensors exhibited a broad dynamic range from 1 CFU/mL to 108 CFU/mL. The Apta-MIPs performance surpasses those obtained for Aptasensors alone and MIPs alone, demonstrating the high efficiency of the double recognition effect that originates from the affinity between aptamer and bacteria and target-specific cavities on the polymer. This is the first study in which aptamers and imprinted polymers were used as a hybrid bioreceptors for multiplexed detection of bacteria. The Apta-MIP sensors produced in this study can be used as a point-of-care diagnostic tool for bacteria-related diseases and test of water quality.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Stichwörter der Autor:innen
Substanzen
Autor:innen und Institutionen
- Department of Electronic and Electrical Engineering, University of Bath, Bath, BA2 7AY, United Kingdom; Centre for Bioengineering & Biomedical Technologies (CBio), University of Bath, Bath, BA2 7AY, United Kingdom.
- Department of Life Sciences, University of Bath, Bath, BA2 7AY, United Kingdom; School of Cellular and Molecular Medicine, University of Bristol, Bristol, BS8 1TD, United Kingdom.
- Centre for Bioengineering & Biomedical Technologies (CBio), University of Bath, Bath, BA2 7AY, United Kingdom; Department of Chemical Engineering, University of Bath, Bath, BA2 7AY, United Kingdom.
- Department of Electronic and Electrical Engineering, University of Bath, Bath, BA2 7AY, United Kingdom; Centre for Bioengineering & Biomedical Technologies (CBio), University of Bath, Bath, BA2 7AY, United Kingdom. Elec…
Zitieren
APA
Agar, M., Laabei, M., Leese, H. S., & Estrela, P. (2025). Aptamer-molecularly imprinted polymer sensors for the detection of bacteria in water. Biosensors and Bioelectronics, 272, 117136. https://doi.org/10.1016/j.bios.2025.117136
Vancouver
Agar M, Laabei M, Leese HS, Estrela P. Aptamer-molecularly imprinted polymer sensors for the detection of bacteria in water. Biosensors and Bioelectronics. 2025;272:117136. doi:10.1016/j.bios.2025.117136
BibTeX
@article{Agar2025,
author = {Agar, Meltem and Laabei, Maisem and Leese, Hannah S and Estrela, Pedro},
title = {Aptamer-molecularly imprinted polymer sensors for the detection of bacteria in water},
journal = {Biosensors and Bioelectronics},
year = {2025},
volume = {272},
pages = {117136},
doi = {10.1016/j.bios.2025.117136}
}
EUVIMED