Shoulder kinematics during cyclic overhead work are affected by a passive arm support exoskeleton
Applied Ergonomics · 2024
DOI: 10.1016/j.apergo.2024.104357 ↗Kurz gefasst
Fachartikel in der Zeitschrift Applied Ergonomics, 2024. Verfasst von Giulia Casu und 8 weiteren Autor:innen. Beteiligte Einrichtung: Department of Mechanical, Chemical and Materials Engineering, University of Cagliari, Cagliari, Italy. Electronic address: giuliacasu.gc@outlook.it. Hauptthemen laut MEDLINE: Exoskeleton Device, Torque. Die Arbeit wurde bisher 4-mal zitiert (Crossref) und nennt 41 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0). Gefördert von: University of California, San Francisco, The Center for Construction Research and Training.
Abstract (Originalsprache)
PURPOSE: We investigated the influence of passive arm-support exoskeleton (ASE) with different levels of torque (50, 75, and 100%) on upper arm osteokinematics. METHODS: Twenty participants completed a cyclic overhead drilling task with and without ASE. Task duration, joint angles, and angular acceleration peaks were analyzed during ascent and descent phases of the dominant upper arm. RESULTS: Maximum ASE torque was associated with decreased peak acceleration during ascent (32.2%; SD 17.8; p 0.001) and internally rotated arm posture (17.6°; SD 12.1; p < 0.001), with minimal changes in arm abduction. CONCLUSION: The small arm accelerations and changes in osteokinematics we observed, support the use of this ASE, even while performing overhead cyclic tasks with the highest level of support.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Stichwörter der Autor:innen
Autor:innen und Institutionen
- Department of Mechanical, Chemical and Materials Engineering, University of Cagliari, Cagliari, Italy. Electronic address: giuliacasu.gc@outlook.it.
- School of Public Health, University of California, Berkeley, CA, USA.
- Department of Medicine, University of California, San Francisco, CA, USA; School of Public Health, University of California, Berkeley, CA, USA.
- Virginia Tech, Department of Industrial and System Engineering, Blacksburg, VA, USA.
- Department of Medicine, University of California, San Francisco, CA, USA.
- Department of Mechanical, Chemical and Materials Engineering, University of Cagliari, Cagliari, Italy.
Förderung
- University of California, San Francisco
- The Center for Construction Research and Training
Zitieren
APA
Casu, G., Barajas-Smith, I., Barr, A., Phillips, B., Kim, S., Nussbaum, M. A., Rempel, D., Pau, M., & Harris-Adamson, C. (2024). Shoulder kinematics during cyclic overhead work are affected by a passive arm support exoskeleton. Applied Ergonomics. https://doi.org/10.1016/j.apergo.2024.104357
Vancouver
Casu G, Barajas-Smith I, Barr A, Phillips B, Kim S, Nussbaum MA, et al. Shoulder kinematics during cyclic overhead work are affected by a passive arm support exoskeleton. Applied Ergonomics. 2024. doi:10.1016/j.apergo.2024.104357
BibTeX
@article{Casu2024,
author = {Casu, Giulia and Barajas-Smith, Isaiah and Barr, Alan and Phillips, Brandon and Kim, Sunwook and Nussbaum, Maury A and Rempel, David and Pau, Massimiliano and Harris-Adamson, Carisa},
title = {Shoulder kinematics during cyclic overhead work are affected by a passive arm support exoskeleton},
journal = {Applied Ergonomics},
year = {2024},
doi = {10.1016/j.apergo.2024.104357}
}
EUVIMED