TiO2-ZnO rodlike nanocomposite as photoanode in DSSC yielding 7.38% power conversion efficiency with N3 dye
Discover Chemistry · 13.05.2026 · 3 (1)
DOI: 10.1007/s44371-026-00717-2 ↗Kurz gefasst
Fachartikel in der Zeitschrift Discover Chemistry, online erschienen am 13.05.2026. Verfasst von Ankush G. Thate und 7 weiteren Autor:innen. Die Arbeit wurde bisher 2-mal zitiert (Crossref) und nennt 43 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0).
Abstract (Originalsprache)
TiO₂-ZnO nanocomposites synthesised via a simple direct chemical precipitation route were investigated as composition controlled photoanodes in dye-sensitized solar cells (DSSCs) operating under low irradiance conditions. A systematic examination of the TiO₂:ZnO molar ratio impact on structural, morphological, optical, and photovoltaic properties was conducted. X-ray diffraction confirmed the presence of both rutile TiO₂ and hexagonal wurtzite ZnO phases, without any secondary phases being formed, while electron microscopy showed interconnected nanorod assemblies, most pronounced in the TiO₂ rich composite with a 3:1 molar ratio (AB3). A gradual red shift and reduction in the effective optical bandgap from 3.10 to 2.95 eV across a composite series were observed using UV-visible spectroscopy, and were attributed to interfacial and defect related electronic states rather than a modification to the bulk band structure. X-ray photoelectron spectroscopy confirmed the expected oxidation states of Ti and Zn, with O 1s asymmetry indicating oxygen-vacancy-related or interfacial states. DSSCs made with an AB3 photoanode achieved the highest power conversion efficiency of 7.38% under low light conditions of 20 mW cm−2, utilising a 0.1 M I−/I₃− redox electrolyte, with a short circuit current density of 3.25 mA cm−2, an open circuit voltage of 946.96 mV, and a fill factor of 48%. Electrochemical impedance spectroscopy revealed a lower charge transfer resistance in AB3, suggesting reduced interfacial recombination. These results confirm the efficacy of TiO₂-ZnO nanorod composites in facilitating efficient DSSC operation under low light conditions.
Zitieren
APA
Thate, A. G., Pakhare, K., Patil, S., Bhuse, V., Dhodamani, A., Kamble, A., Chougale, U., & Bhuse, D. (2026). TiO2-ZnO rodlike nanocomposite as photoanode in DSSC yielding 7.38% power conversion efficiency with N3 dye. Discover Chemistry, 3(1). https://doi.org/10.1007/s44371-026-00717-2
Vancouver
Thate AG, Pakhare K, Patil S, Bhuse V, Dhodamani A, Kamble A, et al. TiO2-ZnO rodlike nanocomposite as photoanode in DSSC yielding 7.38% power conversion efficiency with N3 dye. Discover Chemistry. 2026;3(1). doi:10.1007/s44371-026-00717-2
BibTeX
@article{Thate2026,
author = {Thate, Ankush G. and Pakhare, Keshav and Patil, Satish and Bhuse, Vijaykumar and Dhodamani, Ananta and Kamble, Amit and Chougale, Uttam and Bhuse, Darpan},
title = {TiO2-ZnO rodlike nanocomposite as photoanode in DSSC yielding 7.38% power conversion efficiency with N3 dye},
journal = {Discover Chemistry},
year = {2026},
volume = {3},
number = {1},
doi = {10.1007/s44371-026-00717-2}
}
EUVIMED