Characterization of heat-processed artificial lightweight aggregates from polyethylene terephthalate plastic waste
Discover Civil Engineering · 30.07.2024 · 1 (1)
DOI: 10.1007/s44290-024-00046-2 ↗Kurz gefasst
Fachartikel in der Zeitschrift Discover Civil Engineering, online erschienen am 30.07.2024. Verfasst von Chikadibia Kalu Awa Uche und 3 weiteren Autor:innen. Die Arbeit wurde bisher 7-mal zitiert (Crossref) und nennt 96 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
Plastic waste is an undeniable source of pollution that threatens the existence of the earth’s flora and fauna. The bulk of plastic waste generated globally does not go through the proper methods of disposal but is carelessly discarded into the aquatic or terrestrial environment. Current recycling efforts are largely inadequate and disposal in landfills is still fraught with environmental and land use challenges. The proper disposal of plastic waste, as well as mitigating the environmental, social, and health impacts of extracting natural aggregates can be achieved by incorporating plastic waste as aggregates in the construction industry. This paper presents a characterization of aggregates manufactured from polyethylene terephthalate plastic waste using thermal/mechanical methods. From the cost analysis, 24,341.67 Ugx (6.09 USD) was spent to produce 1 kg of PET aggregates. Morphological, intrinsic and mechanical characteristics of the produced aggregates were established using standard procedures and equipment. The results of morphological characterization indicate an irregular shaped aggregate with smooth surface, a dense graded aggregate with a fineness modulus of 4.25, flakiness index of 26%, elongation index of 16% and particle index of 13. Intrinsic characterization yielded particle density of 1330 kg/m 3 , bulk density of coarse aggregates of 715 kg/m 3 and water absorption of 0.445%. Mechanical characteristics of aggregates were evaluated, with compressive strength of 50Mpa, Aggregate Crushing Value of 37%, Ten Percent Fines Value of 71KN, Aggregate Impact Value of 24% and Aggregate Abrasion Value of 20%. The characteristics of PET aggregates confirm their suitability for application in structural lightweight concrete and rigid pavement. The produced PET aggregates can be considered in mix design as a total or partial replacement of natural aggregates in concrete.
Zitieren
APA
Uche, C. K. A., Abubakar, S. A., Nnamchi, S. N., & Mundu, M. M. (2024). Characterization of heat-processed artificial lightweight aggregates from polyethylene terephthalate plastic waste. Discover Civil Engineering, 1(1). https://doi.org/10.1007/s44290-024-00046-2
Vancouver
Uche CKA, Abubakar SA, Nnamchi SN, Mundu MM. Characterization of heat-processed artificial lightweight aggregates from polyethylene terephthalate plastic waste. Discover Civil Engineering. 2024;1(1). doi:10.1007/s44290-024-00046-2
BibTeX
@article{Uche2024,
author = {Uche, Chikadibia Kalu Awa and Abubakar, Sani Aliyu and Nnamchi, Stephen Ndubuisi and Mundu, Muhamad Mustafa},
title = {Characterization of heat-processed artificial lightweight aggregates from polyethylene terephthalate plastic waste},
journal = {Discover Civil Engineering},
year = {2024},
volume = {1},
number = {1},
doi = {10.1007/s44290-024-00046-2}
}
EUVIMED