EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Influence of Film Thickness on Nanofabrication of Graphene Oxide

Chuan Tang, Lei Chen, Linmao Qian

Nanomanufacturing and Metrology · 2024-12 · 7 (1)

DOI: 10.1007/s41871-024-00226-9 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Nanomanufacturing and Metrology, online erschienen am 03.04.2024. Verfasst von Chuan Tang und 2 weiteren Autor:innen. Die Arbeit wurde bisher 18-mal zitiert (Crossref) und nennt 55 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Natural Science Foundation of China, Sichuan Province Science and Technology Support Program, Fundamental Research Funds for Central Universities of the Central South University.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Nanofabrication of two-dimensional materials through mechanical machining is normally influenced by not only process parameters such as load and velocity but also intrinsic properties such as strength and thickness. Herein, we examined the effects of graphene oxide (GO) film thickness on nanofabrication on the plane surfaces and at the step edges using scanning probe microscope lithography. The material removal of GO initiates at the load above a critical value, which strongly depends on film thickness and locations. With the increase in film thickness, the critical load decreases monotonically on the plane surfaces but increases gradually at the step edges. Further, the critical load for the GO monolayer at the step edges is at least 25 times lower than that on the plane surfaces, and the gap decreases to around 3 times when GO thickness increases to four layers. Then, mechanical nanofabrication initiating from the GO step edge allows producing various nanopatterns under extremely low loads around 1 nN. Finally, the GO nanostructures are deoxidized by annealing at 800 °C in high-purity argon to restore their highly functionalized conjugated structures, which are supported by X-ray diffraction and Raman characterizations. This work provides a novel approach to fabricating graphene-like nanostructures by deoxidizing GO after nanofabrication, which holds significant potential for applications in graphene-based devices. Graphical Abstract

Förderung

  • National Natural Science Foundation of China
  • Sichuan Province Science and Technology Support Program
  • Fundamental Research Funds for Central Universities of the Central South University

Zitieren

APA

Tang, C., Chen, L., & Qian, L. (2024). Influence of Film Thickness on Nanofabrication of Graphene Oxide. Nanomanufacturing and Metrology, 7(1). https://doi.org/10.1007/s41871-024-00226-9

Vancouver

Tang C, Chen L, Qian L. Influence of Film Thickness on Nanofabrication of Graphene Oxide. Nanomanufacturing and Metrology. 2024;7(1). doi:10.1007/s41871-024-00226-9

BibTeX
@article{Tang2024,
  author = {Tang, Chuan and Chen, Lei and Qian, Linmao},
  title = {Influence of Film Thickness on Nanofabrication of Graphene Oxide},
  journal = {Nanomanufacturing and Metrology},
  year = {2024},
  volume = {7},
  number = {1},
  doi = {10.1007/s41871-024-00226-9}
}
Kostenlos starten →