Development of a Micro w-EDM Pulse Generator with Energy-Optimized Boost Effect for Study on High-Precision Machining of Silicon Carbide Microstructures
International Journal of Precision Engineering and Manufacturing-Green Technology · 2026-03 · 13 (2) · 505-520
DOI: 10.1007/s40684-025-00785-2 ↗Kurz gefasst
Fachartikel in der Zeitschrift International Journal of Precision Engineering and Manufacturing-Green Technology, online erschienen am 08.09.2025. Verfasst von Shun-Tong Chen und 1 weiteren Autor:innen. Die Arbeit wurde bisher 7-mal zitiert (Crossref) und nennt 50 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Taiwan Normal University.
Abstract (Originalsprache)
Silicon carbide (4 H-SiC) is widely used in green energy industries, such as in electric vehicle charging modules and renewable energy power switches. However, its high-resistance, -melting point, and -hardness demand significant energy for machining with conventional w-EDM, making high-precision processing difficult. To address this, a micro w-EDM pulse generator with an energy-optimized boost circuit is developed and presented in this study. In this system, magnetic energy briefly stored in an inductor is converted to electrical energy during pulse-on time and instantly superimposed onto the original input voltage. This discharge energy forms a pulsed current train with superimposed peak values, rapidly breaking the surface barrier of 4 H-SiC to enable efficient gap ignition and arc initiation. Cutting tests using a micro brass wire on 4 H-SiC show that commercial transistorized discharge circuits cause severe slot expansion, damaged layers, and welding-scars, indicating excessive energy consumption, thermal deformation, and failure to meet the precision needs of microstructure fabrication. In contrast, the energy-optimized boost circuit confines each discharge pulse to a narrow width with high-frequency, superimposed peaks, enabling rapid, trace-amount material removal with low energy consumption and minimal thermal shock. Two microstructural arrays—comb-like and curved-fin—are successfully machined, achieving thicknesses as thin as 13 μm, high uniformity, excellent flatness, and aspect ratios exceeding 1:30. The surface roughness remained below Ra 0.292 μm without thermal deformation, confirming the circuit’s effectiveness in preventing excess discharge energy. This advancement enables low-energy wire-cutting discharge machining, particularly suitable for materials with high melting points, hardness, and electrical resistance.
Förderung
- National Taiwan Normal University
Zitieren
APA
Chen, S., & Cai, Y. (2026). Development of a Micro w-EDM Pulse Generator with Energy-Optimized Boost Effect for Study on High-Precision Machining of Silicon Carbide Microstructures. International Journal of Precision Engineering and Manufacturing-Green Technology, 13(2), 505-520. https://doi.org/10.1007/s40684-025-00785-2
Vancouver
Chen S, Cai Y. Development of a Micro w-EDM Pulse Generator with Energy-Optimized Boost Effect for Study on High-Precision Machining of Silicon Carbide Microstructures. International Journal of Precision Engineering and Manufacturing-Green Technology. 2026;13(2):505-520. doi:10.1007/s40684-025-00785-2
BibTeX
@article{Chen2026,
author = {Chen, Shun-Tong and Cai, Yue-Ying},
title = {Development of a Micro w-EDM Pulse Generator with Energy-Optimized Boost Effect for Study on High-Precision Machining of Silicon Carbide Microstructures},
journal = {International Journal of Precision Engineering and Manufacturing-Green Technology},
year = {2026},
volume = {13},
number = {2},
pages = {505--520},
doi = {10.1007/s40684-025-00785-2}
}
EUVIMED