The Influence of Layer Remelting on Microstructure, Porosity, Hardness, and Tensile Properties of M300 Steel Parts Produced by Laser Powder Bed Fusion
Lasers in Manufacturing and Materials Processing · 2026-09 · 13 (3) · 885-906
DOI: 10.1007/s40516-026-00355-7 ↗Kurz gefasst
Fachartikel in der Zeitschrift Lasers in Manufacturing and Materials Processing, online erschienen am 30.06.2026. Verfasst von Janusz Kluczyński und 6 weiteren Autor:innen. Die Arbeit nennt 29 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0). Gefördert von: Narodowe Centrum Nauki.
Abstract (Originalsprache)
In this paper, the influence of additional heat treatment of additively manufactured (AM) M300 steel is discussed, implemented by means of remelting each layer of the material using a laser beam from the AM machine directly during the process. The proposed heat treatment was used for the improvement of the AM process in situ. Research results revealed that using a small laser exposure velocity, it is possible to obtain parts with low porosity both after a single exposure (0.03%) and multiple exposures, including double (0.04%) and triple (0.04%) exposures. Furthermore, a stable increase in hardness with subsequent exposures. The hardness increased from 365.67 ± 3.92 HV after a single exposure to 385.17 ± 4.91 HV, after a triple exposure of each layer. The hardening effect of the remelted area was only registered in the case of exposure of the whole layers, and further improvements by selective hardening were not possible in a part of the layers.
Förderung
- Narodowe Centrum Nauki
Zitieren
APA
Kluczyński, J., Szachogłuchowicz, I., Łuszczek, J., Joska, Z., Tomáš, D., Torzewski, J., & Małek, M. (2026). The Influence of Layer Remelting on Microstructure, Porosity, Hardness, and Tensile Properties of M300 Steel Parts Produced by Laser Powder Bed Fusion. Lasers in Manufacturing and Materials Processing, 13(3), 885-906. https://doi.org/10.1007/s40516-026-00355-7
Vancouver
Kluczyński J, Szachogłuchowicz I, Łuszczek J, Joska Z, Tomáš D, Torzewski J, et al. The Influence of Layer Remelting on Microstructure, Porosity, Hardness, and Tensile Properties of M300 Steel Parts Produced by Laser Powder Bed Fusion. Lasers in Manufacturing and Materials Processing. 2026;13(3):885-906. doi:10.1007/s40516-026-00355-7
BibTeX
@article{Kluczyski2026,
author = {Kluczyński, Janusz and Szachogłuchowicz, Ireneusz and Łuszczek, Jakub and Joska, Zdeněk and Tomáš, Dražan and Torzewski, Janusz and Małek, Marcin},
title = {The Influence of Layer Remelting on Microstructure, Porosity, Hardness, and Tensile Properties of M300 Steel Parts Produced by Laser Powder Bed Fusion},
journal = {Lasers in Manufacturing and Materials Processing},
year = {2026},
volume = {13},
number = {3},
pages = {885--906},
doi = {10.1007/s40516-026-00355-7}
}
EUVIMED