Accuracy and limitations of 1D and Q2D water hammer models for laminar and turbulent flows
Journal of the Brazilian Society of Mechanical Sciences and Engineering · 2025-12 · 47 (12)
DOI: 10.1007/s40430-025-05924-z ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of the Brazilian Society of Mechanical Sciences and Engineering, online erschienen am 17.10.2025. Verfasst von Kamil Urbanowicz und 3 weiteren Autor:innen. Die Arbeit wurde bisher 4-mal zitiert (Crossref) und nennt 58 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: CNPq, Regional Initiative of Excellence by the Polish Minister of Science.
Abstract (Originalsprache)
This article presents a detailed comparison between 1D and Q2D models used for simulating unsteady flows in pressurized conduits, commonly known as water hammer. The 1D model incorporates the effects of unsteady friction through a convolution integral, whereas the Q2D model is a recently developed approach based on the continuum theory of mixtures. Pressure responses from both models were compared against eight selected experimental studies (four for laminar flows and four for turbulent flows). The study qualitatively assessed the models' accuracy in simulating dynamic pressure, average velocity, and shear stress histories, with quantitative analysis focused on dynamic pressure responses. Both models exhibited high accuracy for simulating laminar flows. Additional numerical studies performed for turbulent flows highlighted the influence of the Ghidaoui parameter $$P$$ P on the accuracy of both models. These studies underscored the need for experimental research in the range of low $$P$$ P values and indicated that the Q2D model is suitable for calculations when $$P\ge 3$$ P ≥ 3 . Computational time analysis demonstrated that the Q2D model outperform the 1D model in relatively long tests in terms of efficiency, primarily because the 1D approach relies on a computationally expensive full convolution-based friction formulation. Furthermore, this work showed that the 1D model does not satisfy the Clausius–Duhem inequality criterion because, relying solely on average velocities, it cannot account for the contributions of the inner layers of fluid flow to total energy dissipation.
Förderung
- CNPq
- Regional Initiative of Excellence by the Polish Minister of Science
Zitieren
APA
Urbanowicz, K., Andrade, D. M., Kubrak, M., & Kodura, A. (2025). Accuracy and limitations of 1D and Q2D water hammer models for laminar and turbulent flows. Journal of the Brazilian Society of Mechanical Sciences and Engineering, 47(12). https://doi.org/10.1007/s40430-025-05924-z
Vancouver
Urbanowicz K, Andrade DM, Kubrak M, Kodura A. Accuracy and limitations of 1D and Q2D water hammer models for laminar and turbulent flows. Journal of the Brazilian Society of Mechanical Sciences and Engineering. 2025;47(12). doi:10.1007/s40430-025-05924-z
BibTeX
@article{Urbanowicz2025,
author = {Urbanowicz, Kamil and Andrade, Douglas Monteiro and Kubrak, Michał and Kodura, Apoloniusz},
title = {Accuracy and limitations of 1D and Q2D water hammer models for laminar and turbulent flows},
journal = {Journal of the Brazilian Society of Mechanical Sciences and Engineering},
year = {2025},
volume = {47},
number = {12},
doi = {10.1007/s40430-025-05924-z}
}
EUVIMED