EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Wear Induced Sub-surface Deformation Characteristics of a 26 Wt% Cr White Cast Iron Subjected to a Destabilization Heat Treatment

U. Pranav Nayak, Florian Schäfer, Frank Mücklich, María Agustina Guitar

Tribology Letters · 2023-03 · 71 (1)

DOI: 10.1007/s11249-022-01683-3 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Tribology Letters, online erschienen am 04.12.2022. Verfasst von U. Pranav Nayak und 3 weiteren Autor:innen. Die Arbeit wurde bisher 6-mal zitiert (Crossref) und nennt 47 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Universität des Saarlandes.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

In the present work, the sub-surface microstructure of a heat treated and worn 26 wt% Cr white cast iron was investigated to gain better insight into the tribological behaviour of the material. The samples were destabilized at 980 °C for 0 (Q_0), 30 (Q_30) and 90 (Q_90) minutes followed by air cooling, and later subjected to dry-sliding linear reciprocating wear tests. The microstructural characterization of the area under the wear track was carried out using a combination of SEM, EDS and EBSD. Additionally, nanoindentation (NI) measurements were used to corroborate the mechanical behaviour with the microstructural observations. EBSD and NI measurements indicated that the matrix area underneath the wear track in Q_0 had undergone significant plastic deformation resulting in a drastic increase in hardness, whereas no such phenomena was observed in the Q_90. This was attributable to the relatively high amount of retained austenite in the former and a predominately martensitic matrix in the latter. Moreover, the large M 7 C 3 eutectic carbides were less cracked in the destabilized samples compared to the as-cast sample owing to the presence of martensite and dispersed secondary carbides, leading to an increased matrix load-bearing capacity. These factors led to the destabilized samples showing a lower wear rate compared to the as-cast sample, and the Q_0 showing the best wear resistance amongst all the samples.

Förderung

  • Universität des Saarlandes

Zitieren

APA

Nayak, U. P., Schäfer, F., Mücklich, F., & Guitar, M. A. (2023). Wear Induced Sub-surface Deformation Characteristics of a 26 Wt% Cr White Cast Iron Subjected to a Destabilization Heat Treatment. Tribology Letters, 71(1). https://doi.org/10.1007/s11249-022-01683-3

Vancouver

Nayak UP, Schäfer F, Mücklich F, Guitar MA. Wear Induced Sub-surface Deformation Characteristics of a 26 Wt% Cr White Cast Iron Subjected to a Destabilization Heat Treatment. Tribology Letters. 2023;71(1). doi:10.1007/s11249-022-01683-3

BibTeX
@article{Nayak2023,
  author = {Nayak, U. Pranav and Schäfer, Florian and Mücklich, Frank and Guitar, María Agustina},
  title = {Wear Induced Sub-surface Deformation Characteristics of a 26 Wt% Cr White Cast Iron Subjected to a Destabilization Heat Treatment},
  journal = {Tribology Letters},
  year = {2023},
  volume = {71},
  number = {1},
  doi = {10.1007/s11249-022-01683-3}
}
Kostenlos starten →