Bifunctional CuO thin films: tuning antibacterial and photocatalytic performance through precursor molarity by spray pyrolysis
Optical and Quantum Electronics · 19.09.2026 · 58 (11)
DOI: 10.1007/s11082-026-09142-2 ↗Kurz gefasst
Fachartikel in der Zeitschrift Optical and Quantum Electronics, online erschienen am 19.09.2026. Verfasst von Mouad Chettab und 7 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 49 Literaturangaben.
Abstract (Originalsprache)
Copper oxide (CuO) thin films were successfully deposited by spray pyrolysis using precursor solutions with different molarities (0.02, 0.05 and 0.1 M) in order to investigate the correlation between growth conditions and multifunctional properties. Structural analysis confirmed the formation of monoclinic CuO with improved crystallinity as the molarity increased. The crystallite size increased to \documentclass[12pt]{minimal} \usepackage{amsmath} \usepackage{wasysym} \usepackage{amsfonts} \usepackage{amssymb} \usepackage{amsbsy} \usepackage{mathrsfs} \usepackage{upgreek} \setlength{\oddsidemargin}{-69pt} \begin{document}$$\sim $$\end{document} 17 nm while the strain and dislocation density decreased, indicating enhanced crystal quality at higher precursor concentrations. In FTIR spectra, it was observed that the bonding at 400 and 402 cm−1 which attributed to Cu–O stretching bonds which confirms the formation of CuO phase. Surface morphology analysis showed that higher molarity led to increased roughness and grain size to \documentclass[12pt]{minimal} \usepackage{amsmath} \usepackage{wasysym} \usepackage{amsfonts} \usepackage{amssymb} \usepackage{amsbsy} \usepackage{mathrsfs} \usepackage{upgreek} \setlength{\oddsidemargin}{-69pt} \begin{document}$$\sim $$\end{document} 61 nm and \documentclass[12pt]{minimal} \usepackage{amsmath} \usepackage{wasysym} \usepackage{amsfonts} \usepackage{amssymb} \usepackage{amsbsy} \usepackage{mathrsfs} \usepackage{upgreek} \setlength{\oddsidemargin}{-69pt} \begin{document}$$\sim $$\end{document} 1.9 \documentclass[12pt]{minimal} \usepackage{amsmath} \usepackage{wasysym} \usepackage{amsfonts} \usepackage{amssymb} \usepackage{amsbsy} \usepackage{mathrsfs} \usepackage{upgreek} \setlength{\oddsidemargin}{-69pt} \begin{document}$$\times $$\end{document} 105 nm2 respectively, reflecting a smoother and more homogeneous surface. Optical studies revealed a decrease in optical bandgap to 1.41 eV at 0.1 M. The Urbach energy increased to 0.89 eV at the same molarity indicating a low disorder and defect density in the films. Electrical measurements demonstrated a significant enhancement in conductivity with increasing molarity reaching to 7.88 × 1013 cm−3, driven by the combined effect of higher carrier concentration and improved mobility due to reduced grain boundary scattering. Photocatalytic performance evaluated through methylene blue (MB) degradation under natural sunlight revealed that the 0.02 M film exhibited the highest degradation efficiency ~70.21%, which is attributed to its higher surface area ~ 67.91 m2 /g and greater density of active sites. In contrast, antibacterial activity tests showed that films prepared at higher molarity 0.1 M exhibited superior bactericidal performance, particularly against Gram-negative bacteria, due to enhanced Cu2+ ion release and increased generation of reactive oxygen species (ROS). These findings demonstrate a clear trade-off between photocatalytic and antibacterial performance, governed by precursor molarity. The study highlights molarity control as a simple and effective strategy for tailoring CuO thin films toward eco-friendly multifunctional applications in environmental remediation and antimicrobial coatings.
Zitieren
APA
Chettab, M., Djaaboube, H., Bouachiba, Y., Harrat, S., Taabouche, A., Aouati, R., Abed, S., & Abdelaziz, O. (2026). Bifunctional CuO thin films: tuning antibacterial and photocatalytic performance through precursor molarity by spray pyrolysis. Optical and Quantum Electronics, 58(11). https://doi.org/10.1007/s11082-026-09142-2
Vancouver
Chettab M, Djaaboube H, Bouachiba Y, Harrat S, Taabouche A, Aouati R, et al. Bifunctional CuO thin films: tuning antibacterial and photocatalytic performance through precursor molarity by spray pyrolysis. Optical and Quantum Electronics. 2026;58(11). doi:10.1007/s11082-026-09142-2
BibTeX
@article{Chettab2026,
author = {Chettab, Mouad and Djaaboube, Halima and Bouachiba, Yassine and Harrat, Safia and Taabouche, Adel and Aouati, Redha and Abed, Sihem and Abdelaziz, Ouidad},
title = {Bifunctional CuO thin films: tuning antibacterial and photocatalytic performance through precursor molarity by spray pyrolysis},
journal = {Optical and Quantum Electronics},
year = {2026},
volume = {58},
number = {11},
doi = {10.1007/s11082-026-09142-2}
}
EUVIMED