EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Electrical characterization of Ag/MoO3−x/p-Si Schottky diodes based on MoO3−x synthesized via sol–gel method: an investigation on frequency and voltage dependence

Adem Mutlu, Cem Tozlu

Journal of Materials Science: Materials in Electronics · 2024-04 · 35 (11)

DOI: 10.1007/s10854-024-12559-8 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Materials Science: Materials in Electronics, online erschienen am 19.04.2024. Verfasst von Adem Mutlu und 1 weiteren Autor:innen. Die Arbeit wurde bisher 16-mal zitiert (Crossref) und nennt 60 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Türkiye Bilimsel ve Teknolojik Araştırma Kurumu, Ege University.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

MoO 3− x is a commonly used buffer layer in organic based optoelectronic devices to align energy level between active semiconductor and metal layer. The purpose of this study is to show the effects of the MoO 3− x interlayer by comparing with a reference device without MoO 3− x interlayer. To evaluate the effect of MoO 3− x interlayer synthesized by sol–gel method, basic important parameters such as ideality factor ( n ), barrier height ( $$\varnothing$$ ∅ B ), interface states ( N ss ) and series resistance ( R s ) of Ag/MoO 3− x /p-Si and Ag/p-Si Schottky diodes were calculated by electrical characterization methods. The current–voltage ( I–V ) measurements show that the ideality factor for the p-Si/Ag reference diode was decreased from 2.4 to 1.9 while rectification factor increasing 44.6 times using MoO 3− x interlayer, and frequency–dependent measurements ( C–V–f , G–V–f ) were carried out to elucidate this deviation at room temperature for MoO 3− x -based diode. From the XPS analysis, it was seen that Mo +6 and Mo +5 oxidation states were intense on the surface of the MoO 3− x film, and the Mo +4 oxidation state increased as it went into the bulk. The changes in R s and N ss due to the energy levels formed by the Mo +6 and Mo +5 oxidation steps at the interface are depicted. In addition, the energy density distribution profile of N ss was obtained using the I–V characteristics for various forward bias voltages range from 2.1 × 10 12 to 2.5 × 10 12 eV −1 cm −2 . Based on the experimental results, the sol–gel synthesized MoO 3− x thin film exhibits favorable rectification characteristics and holds promise for application as a Schottky diode.

Förderung

  • Türkiye Bilimsel ve Teknolojik Araştırma Kurumu
  • Ege University

Zitieren

APA

Mutlu, A., & Tozlu, C. (2024). Electrical characterization of Ag/MoO3−x/p-Si Schottky diodes based on MoO3−x synthesized via sol–gel method: an investigation on frequency and voltage dependence. Journal of Materials Science: Materials in Electronics, 35(11). https://doi.org/10.1007/s10854-024-12559-8

Vancouver

Mutlu A, Tozlu C. Electrical characterization of Ag/MoO3−x/p-Si Schottky diodes based on MoO3−x synthesized via sol–gel method: an investigation on frequency and voltage dependence. Journal of Materials Science: Materials in Electronics. 2024;35(11). doi:10.1007/s10854-024-12559-8

BibTeX
@article{Mutlu2024,
  author = {Mutlu, Adem and Tozlu, Cem},
  title = {Electrical characterization of Ag/MoO3−x/p-Si Schottky diodes based on MoO3−x synthesized via sol–gel method: an investigation on frequency and voltage dependence},
  journal = {Journal of Materials Science: Materials in Electronics},
  year = {2024},
  volume = {35},
  number = {11},
  doi = {10.1007/s10854-024-12559-8}
}
Kostenlos starten →