EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Experimental Characterisation of Cure-Dependent Spring-Back Behaviour of Metal-Composite Laminates in a Hot-Pressing Process

Shichen Liu, Jos Sinke, Clemens Dransfeld

Applied Composite Materials · 2025-02 · 32 (1) · 173-198

DOI: 10.1007/s10443-024-10266-5 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Applied Composite Materials, online erschienen am 14.09.2024. Verfasst von Shichen Liu und 2 weiteren Autor:innen. Die Arbeit wurde bisher 10-mal zitiert (Crossref) und nennt 50 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: China Scholarship Council.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This study focuses on the spring-back as a function of the degree of cure on single-curved metal-composite laminates. The manufacturing through a hot-pressing process involves different (curing) stages and can reduce the spring-back with the proper combination of forming and curing. The cure-dependent spring-back is measured and analysed as a function of material constituents, fibre directions, laminate layups, and the process parameters including temperature, holding time and pressure. The results demonstrate that the spring-back ratio after full-cured process is relatively small and mainly depends on the mechanical properties of the metal sheet in laminates. However, temperature and time have a significant effect on the spring-back of partially-cured laminates and the same type of fibre prepreg combined with two different metal sheets have similar trends of spring-back reduction. Moreover, the study found that the hybrid laminates with aluminium sheet delaminate at low pressure after full-cured, while the delamination disappears as the pressure increases. The characterisation on cure-dependency of the spring-back contributes to a better understanding of the deformability of the metal-composite laminates during the hot-pressing process and offers an opportunity to tune the spring-back of these laminates.

Förderung

  • China Scholarship Council

Zitieren

APA

Liu, S., Sinke, J., & Dransfeld, C. (2025). Experimental Characterisation of Cure-Dependent Spring-Back Behaviour of Metal-Composite Laminates in a Hot-Pressing Process. Applied Composite Materials, 32(1), 173-198. https://doi.org/10.1007/s10443-024-10266-5

Vancouver

Liu S, Sinke J, Dransfeld C. Experimental Characterisation of Cure-Dependent Spring-Back Behaviour of Metal-Composite Laminates in a Hot-Pressing Process. Applied Composite Materials. 2025;32(1):173-198. doi:10.1007/s10443-024-10266-5

BibTeX
@article{Liu2025,
  author = {Liu, Shichen and Sinke, Jos and Dransfeld, Clemens},
  title = {Experimental Characterisation of Cure-Dependent Spring-Back Behaviour of Metal-Composite Laminates in a Hot-Pressing Process},
  journal = {Applied Composite Materials},
  year = {2025},
  volume = {32},
  number = {1},
  pages = {173--198},
  doi = {10.1007/s10443-024-10266-5}
}
Kostenlos starten →