Apatite-like calcium phosphate deposition and physicochemical properties of an aspartic acid–functionalized hydraulic cement
Clinical Oral Investigations · 2026
DOI: 10.1007/s00784-026-07196-w ↗Kurz gefasst
Fachartikel in der Zeitschrift Clinical Oral Investigations, 2026. Verfasst von Elias Daniel Covas Rodrigues und 7 weiteren Autor:innen. Beteiligte Einrichtung: School of Dentistry of Ribeirão Preto (FORP/USP), Department of Restorative Dentistry, University of São Paulo, Ribeirão Preto, SP, Brazil. Hauptthemen laut MEDLINE: Calcium Compounds, Aspartic Acid, Silicates, Aluminum Compounds. Die Arbeit nennt 35 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Fundação de Amparo à Pesquisa do Estado de São Paulo.
Abstract (Originalsprache)
Objectives
This study evaluated the effects of aspartic acid modification on the physicochemical properties and phosphate-associated surface response of a hydraulic calcium silicate cement. Materials and methods White mineral trioxide aggregate (MTA) was mixed using 0%, 25%, 50%, 75%, or 100% (v/v) of a 4 g/L aspartic acid stock solution. Final setting time, solubility, pH, and Ca²⁺ concentration in the immersion solution were evaluated after seven days in deionized water ( n = 10). Surface roughness, morphology, elemental composition, and phosphate- and carbonate-associated spectral features were assessed after 30 days of storage in deionized water or phosphate-buffered saline (PBS). The Ap/C spectral ratio was calculated from the integrated ATR-FTIR band areas. Data were analyzed using one- or two-way ANOVA followed by Tukey’s test (α = 0.05).
Results
The 25% formulation showed the shortest setting time, whereas the 100% formulation showed the longest ( p < 0.001). All aspartic acid-containing formulations exhibited greater solubility and lower Ca²⁺ concentrations than the control ( p < 0.05), and the 50%, 75%, and 100% formulations exceeded the recommended solubility limit. The 25% formulation had the lowest pH, whereas the control, 75%, and 100% formulations maintained similar alkaline values. Surface roughness was lowest for the 25% formulation and highest for the 100% formulation, with no significant effect of storage medium. EDS detected negligible surface phosphorus after storage in deionized water but marked phosphorus content after PBS storage. Ap/C analysis showed significant main effects of cement formulation and storage medium, without a significant interaction. The 25%, 50%, and 75% formulations exhibited higher marginal Ap/C ratios than the 0% and 100% formulations.
Conclusions
Aspartic acid produced non-linear and formulation-dependent changes in the evaluated properties. Higher Ap/C ratios reflected differences in relative spectral composition but did not confirm increased apatite formation or a crystalline apatite phase. Ca–P-rich surface deposition depended on phosphate supplied by the storage medium, and no formulation improved all evaluated outcomes.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Stichwörter der Autor:innen
Substanzen
Autor:innen und Institutionen
- School of Dentistry of Ribeirão Preto (FORP/USP), Department of Restorative Dentistry, University of São Paulo, Ribeirão Preto, SP, Brazil.
- University of Ribeirão Preto, Ribeirão Preto, SP, Brazil.
- Universitätsklinikum Carl Gustav Carus an der Technischen Universität Dresden, Dresden, Germany.
- School of Dentistry of Ribeirão Preto (FORP/USP), Department of Restorative Dentistry, University of São Paulo, Ribeirão Preto, SP, Brazil. rauccineto@usp.br.
Förderung
- Fundação de Amparo à Pesquisa do Estado de São Paulo
Zitieren
APA
Rodrigues, E. D. C., Polizeli, V. M., de Sousa, J. T., Pereira, L. F., Palma-Dibb, R. G., de Castro-Raucci, L. M. S., Danelon, M., & Raucci-Neto, W. (2026). Apatite-like calcium phosphate deposition and physicochemical properties of an aspartic acid–functionalized hydraulic cement. Clinical Oral Investigations. https://doi.org/10.1007/s00784-026-07196-w
Vancouver
Rodrigues EDC, Polizeli VM, de Sousa JT, Pereira LF, Palma-Dibb RG, de Castro-Raucci LMS, et al. Apatite-like calcium phosphate deposition and physicochemical properties of an aspartic acid–functionalized hydraulic cement. Clinical Oral Investigations. 2026. doi:10.1007/s00784-026-07196-w
BibTeX
@article{Rodrigues2026,
author = {Rodrigues, Elias Daniel Covas and Polizeli, Victor Miguel and de Sousa, Júlia Tavares and Pereira, Larissa Fernanda and Palma-Dibb, Regina Guenka and de Castro-Raucci, Larissa Moreira Spinola and Danelon, Marcelle and Raucci-Neto, Walter},
title = {Apatite-like calcium phosphate deposition and physicochemical properties of an aspartic acid–functionalized hydraulic cement},
journal = {Clinical Oral Investigations},
year = {2026},
doi = {10.1007/s00784-026-07196-w}
}
EUVIMED