EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Spinous process resistance to different materials and looping techniques for interspinous lumbar vertebropexy

Jonas Widmer iD, Anna-Katharina Calek, Marie-Rosa Fasser, Mauro Suter, Brian Allen, Mazda Farshad

European Spine Journal · 2025

DOI: 10.1007/s00586-025-08724-0 ↗

Kurz gefasst

Fachartikel in der Zeitschrift European Spine Journal, 2025. Verfasst von Jonas Widmer und 5 weiteren Autor:innen. Beteiligte Einrichtung: Spine Biomechanics, Department of Orthopedic Surgery, Balgrist University Hospital, University of Zurich, Balgrist Campus, Lengghalde 5, Zurich, 8008…. Hauptthemen laut MEDLINE: Lumbar Vertebrae, Spinal Fusion. Die Arbeit wurde bisher 5-mal zitiert (Crossref) und nennt 20 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: University of Zurich.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Purpose

Semi-rigid spinal stabilization has been explored as an alternative to spinal fusion, and early experience with spinal segment augementation (“vertebropexy”) is promising. The main technical challenge is to maintain the integrity of the spinous processes during loading. This study aimed to compare different looping materials and techniques with respect to their performance in maintaining spinous process integrity.

Methods

One hundred and five thoracolumbar vertebrae were tested with various looping materials and techniques; the “Tunnel-only” double-loop technique was tested with a synthetic tape (FiberTape ® ), bovine tendon, and a hybrid tape option. Additionally, the performance of the synthetic tape was tested for other augmentation techniques such as the “Figure-of-eight” looping technique, a double-loop combination of tunneling and cortical wrapping, and a double-loop with “Cortical wrapping only”. Biomechanical testing was performed by uniaxial caudo-cranial distraction to failure.

Results

The loads required to cause spinous process failure were lowest with the synthetic tape, followed by tendon and hybrid constructs by tendency (419 N vs. 487 N vs. 519 N) in the “Tunnel-only” double-loop technique. The comparison showed that the “Tunnel + cortical wrapping” technique required significantly higher forces to induce failure compared to other techniques, particularly the “Tunnel only” method ( p < 0.001).

Conclusion

The choice of the looping technique and material in lumbar interspinous vertebropexy significantly affects the resistance of the spinous process to load. Techniques that incorporate cortical bone and use tendinous material demonstrate superior resistance to higher forces, compared to methods that involve passing synthetic tape through a hole solely within trabecular bone. Additionally, the role of trabecular bone density in the spinous process is relatively minor when cortical bone is utilized as an abutment for the loop.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

Lumbar VertebraeSpinal FusionBiomechanical PhenomenaHumansAnimalsMaterials TestingCattleWeight-BearingThoracic Vertebrae

Stichwörter der Autor:innen

AugmentationLumbar spineSemi-rigidSpinal stabilizationSpinous processVertebropexy

Autor:innen und Institutionen

  • Spine Biomechanics, Department of Orthopedic Surgery, Balgrist University Hospital, University of Zurich, Balgrist Campus, Lengghalde 5, Zurich, 8008, Switzerland. Jonas.Widmer@balgrist.ch.
  • Department of Orthopedics, Balgrist University Hospital, University of Zurich, Zurich, Switzerland.
  • Balgrist University Hospital, University Spine Center Zurich, University of Zurich, Zurich, Switzerland.
  • Spine Biomechanics, Department of Orthopedic Surgery, Balgrist University Hospital, University of Zurich, Balgrist Campus, Lengghalde 5, Zurich, 8008, Switzerland.

ORCID-Profile: Jonas Widmer

Förderung

  • University of Zurich

Zitieren

APA

Widmer, J., Calek, A. K., Fasser, M. R., Suter, M., Allen, B., & Farshad, M. (2025). Spinous process resistance to different materials and looping techniques for interspinous lumbar vertebropexy. European Spine Journal. https://doi.org/10.1007/s00586-025-08724-0

Vancouver

Widmer J, Calek AK, Fasser MR, Suter M, Allen B, Farshad M. Spinous process resistance to different materials and looping techniques for interspinous lumbar vertebropexy. European Spine Journal. 2025. doi:10.1007/s00586-025-08724-0

BibTeX
@article{Widmer2025,
  author = {Widmer, Jonas and Calek, Anna-Katharina and Fasser, Marie-Rosa and Suter, Mauro and Allen, Brian and Farshad, Mazda},
  title = {Spinous process resistance to different materials and looping techniques for interspinous lumbar vertebropexy},
  journal = {European Spine Journal},
  year = {2025},
  doi = {10.1007/s00586-025-08724-0}
}
Kostenlos starten →