EUVIMEDEUVIMED entdecken
Crossref

Objective measurement of uterine tone using a handheld hardness meter during cesarean delivery: comparison with manual palpation

Satoshi Naruse, Chieko Akinaga, Yusuke Mazda, Yoshiki Nakajima

Journal of Anesthesia · 08.05.2026

DOI: 10.1007/s00540-026-03761-5 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Anesthesia, online erschienen am 08.05.2026. Verfasst von Satoshi Naruse und 3 weiteren Autor:innen. Beteiligte Einrichtung: Perinatal Center, Hamamatsu University School of Medicine, 1-20-1 Handayama, Chuo-Ku, Hamamatsu, Shizuoka, 431-3192, Japan. 07483971@hama-med.ac.jp. Die Arbeit nennt 12 Literaturangaben. Gefördert von: Japan Society for the Promotion of Science.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

To ensure adequate uterine contractions, oxytocin is routinely administered after fetal delivery during cesarean delivery and additional dosing is typically guided by palpation-based assessment. However, manual palpation is subjective and has limited reproducibility and interobserver consistency. The PEK-MP® is a handheld device that quantifies tissue hardness and may provide an objective intraoperative assessment of uterine contraction. This study aimed to examine the relationship between PEK-MP measurements and palpation-defined uterine tone (sufficient vs. insufficient). In this secondary analysis of a randomized controlled trial, 63 paired data points from 21 patients who underwent elective cesarean delivery were analyzed. Uterine fundal hardness was measured at 3, 5, and 9 min after oxytocin administration by obstetrician-performed palpation. In the primary linear mixed-effects model adjusted for measurement timepoint, the estimated difference in PEK-MP values between the palpation-defined groups (sufficient minus insufficient) was 6.3 (95% CI - 1.0 to 13.6; p = 0.094). The measurement timepoint was significantly associated with PEK-MP values, with lower values observed at later assessments. These findings suggest that quantitative hardness measurements may be subject to temporal variation and that the timing of assessment should, therefore, be taken into account when interpreting these values.

Schlagwörter

Stichwörter der Autor:innen

Cesarean deliveryPalpationQuantificationTissue hardness meterUterine contraction

Autor:innen und Institutionen

  • Perinatal Center, Hamamatsu University School of Medicine, 1-20-1 Handayama, Chuo-Ku, Hamamatsu, Shizuoka, 431-3192, Japan. 07483971@hama-med.ac.jp.
  • Department of Anesthesiology and Intensive Care, Hamamatsu University School of Medicine, 1-20-1 Handayama, Chuo-Ku, Hamamatsu, Shizuoka, 431-3192, Japan. 07483971@hama-med.ac.jp.
  • Perinatal Center, Hamamatsu University School of Medicine, 1-20-1 Handayama, Chuo-Ku, Hamamatsu, Shizuoka, 431-3192, Japan.
  • Department of Anesthesiology and Intensive Care, Hamamatsu University School of Medicine, 1-20-1 Handayama, Chuo-Ku, Hamamatsu, Shizuoka, 431-3192, Japan.
  • Department of Obstetric Anesthesiology, Center for Maternal-Fetal and Neonatal Medicine, Saitama Medical Center, Saitama Medical University, 1981 Kamoda, Kawagoe, Saitama, 350-8550, Japan.

Förderung

  • Japan Society for the Promotion of Science

Zitieren

APA

Naruse, S., Akinaga, C., Mazda, Y., & Nakajima, Y. (2026). Objective measurement of uterine tone using a handheld hardness meter during cesarean delivery: comparison with manual palpation. Journal of Anesthesia. https://doi.org/10.1007/s00540-026-03761-5

Vancouver

Naruse S, Akinaga C, Mazda Y, Nakajima Y. Objective measurement of uterine tone using a handheld hardness meter during cesarean delivery: comparison with manual palpation. Journal of Anesthesia. 2026. doi:10.1007/s00540-026-03761-5

BibTeX
@article{Naruse2026,
  author = {Naruse, Satoshi and Akinaga, Chieko and Mazda, Yusuke and Nakajima, Yoshiki},
  title = {Objective measurement of uterine tone using a handheld hardness meter during cesarean delivery: comparison with manual palpation},
  journal = {Journal of Anesthesia},
  year = {2026},
  doi = {10.1007/s00540-026-03761-5}
}
Kostenlos starten →