A feasible and cost-effective method to induce distal radius fractures in full-length forearm human cadaveric specimens
Archives of Orthopaedic and Trauma Surgery · 03.11.2026 · 146 (1)
DOI: 10.1007/s00402-026-06549-0 ↗Kurz gefasst
Fachartikel in der Zeitschrift Archives of Orthopaedic and Trauma Surgery, online erschienen am 03.11.2026. Verfasst von Julius Krüger und 5 weiteren Autor:innen. Beteiligte Einrichtung: Trauma Orthopaedic Research Copenhagen Hvidovre (TORCH), Department of Orthopaedic Surgery, Copenhagen University Hospital - Amager and Hvidovre, Hvi…. Hauptthemen laut MEDLINE: Radius Fractures, Wrist Fractures. Die Arbeit nennt 24 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Charité - Universitätsmedizin Berlin.
Abstract (Originalsprache)
Introduction
Reported rates of loss of reduction in nonoperatively treated distal radius fractures (DRF) range from 17 to 71%. Thus, realistic biomechanical models are warranted to test novel immobilization devices that prevent loss of reduction in nonoperative fracture management. Currently available human cadaveric specimen models have several limitations: (i) disrupted soft tissue integrity, (ii) difficulty in replicating complex fracture patterns, and (iii) high technical demands and costs. Therefore, the aim of this study was to establish a feasible and accessible method for inducing DRFs, that accurately reflects in-vivo biomechanical fracture conditions in tissue-intact cadaveric specimens, suitable for testing of novel immobilization devices. Materials and methods Fifteen upper extremity cadaveric specimens were included. Specimens were prepared as full‑length forearm models. Using a repurposed strength training tower as a vertical drop tower, fractures were induced by proximally administering 120–135 J impacts. CT scans were performed pre- and post-fracture induction. All fractures were classified according to the AO/OTA classification.
Results
DRFs were successfully induced in all 15 specimens. A single 120 J impact produced a DRF in 11 out of 15 cases (73%). A second impact was administered in 4 out of 15 specimens (27%). Eleven of the 15 induced DRFs (73%) were classified as AO/OTA type C fractures, most commonly 2R3C3.2. Concomitant distal ulnar fractures were present in 6 cases, concomitant carpal fractures in 9 specimens. The overall cost of the setup amounted to 947 €.
Conclusions
This study presents a feasible, cost-effective method to induce DRFs in tissue-intact, full-length human cadaveric forearm specimens. The setup consistently produces DRFs, predominantly AO/OTA type C, which can, with certain limitations, be utilized for biomechanical testing of immobilization devices, while also being uited for surgical and anatomical education.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Stichwörter der Autor:innen
Autor:innen und Institutionen
- Trauma Orthopaedic Research Copenhagen Hvidovre (TORCH), Department of Orthopaedic Surgery, Copenhagen University Hospital - Amager and Hvidovre, Hvidovre, Denmark.
- Center for Musculoskeletal Surgery, Charité - Universitätsmedizin Berlin, corporate member of Freie Universität Berlin and Humboldt-Universität zu Berlin, Berlin, Germany.
- Berlin Institute of Health at Charité - Universitätsmedizin Berlin, Julius Wolff Institute, Berlin, Germany.
- Exo360, Copenhagen, Denmark.
- Department of Orthopaedic Surgery, Copenhagen University Hospital - Bispebjerg, Copenhagen, Denmark.
- Department of Clinical Medicine, University of Copenhagen, Copenhagen, Denmark.
Förderung
- Charité - Universitätsmedizin Berlin
Zitieren
APA
Krüger, J., Terndrup, M., Thomsen, M. G., von Keudell, A., Andersen, J. A., & Maleitzke, T. (2026). A feasible and cost-effective method to induce distal radius fractures in full-length forearm human cadaveric specimens. Archives of Orthopaedic and Trauma Surgery, 146(1). https://doi.org/10.1007/s00402-026-06549-0
Vancouver
Krüger J, Terndrup M, Thomsen MG, von Keudell A, Andersen JA, Maleitzke T. A feasible and cost-effective method to induce distal radius fractures in full-length forearm human cadaveric specimens. Archives of Orthopaedic and Trauma Surgery. 2026;146(1). doi:10.1007/s00402-026-06549-0
BibTeX
@article{Krger2026,
author = {Krüger, Julius and Terndrup, Mads and Thomsen, Morten Grove and von Keudell, Arvind and Andersen, Jonas Askø and Maleitzke, Tazio},
title = {A feasible and cost-effective method to induce distal radius fractures in full-length forearm human cadaveric specimens},
journal = {Archives of Orthopaedic and Trauma Surgery},
year = {2026},
volume = {146},
number = {1},
doi = {10.1007/s00402-026-06549-0}
}
EUVIMED