The influence of the weight-bearing state on three-dimensional (3D) planning in lower extremity realignment – analysis of novel vs. state-of-the-art planning approaches
Archives of Orthopaedic and Trauma Surgery · 2024
DOI: 10.1007/s00402-024-05289-3 ↗Kurz gefasst
Vergleichsstudie in der Zeitschrift Archives of Orthopaedic and Trauma Surgery, 2024. Verfasst von Sandro Hodel und 6 weiteren Autor:innen. Beteiligte Einrichtung: Balgrist University Hospital, Department of Orthopedics, University of Zurich, Forchstrasse 340, Zurich, 8008, Switzerland. sandro.hodel1@gmail.com. Hauptthemen laut MEDLINE: Weight-Bearing, Imaging, Three-Dimensional, Tomography, X-Ray Computed, Osteotomy. Die Arbeit wurde bisher 7-mal zitiert (Crossref) und nennt 31 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: University of Zurich.
Abstract (Originalsprache)
Background
The use of 3D planning to guide corrective osteotomies of the lower extremity is increasing in clinical practice. The use of computer-tomography (CT) data acquired in supine position neglects the weight-bearing (WB) state and the gold standard in 3D planning involves the manual adaption of the surgical plan after considering the WB state in long-leg radiographs (LLR). However, this process is subjective and dependent on the surgeons experience. A more standardized and automated method could reduce variability and decrease costs.
Purpose
The aim of the study was (1) to compare three different three-dimensional (3D) planning modalities for medial open-wedge high tibial osteotomy (MOWHTO) and (2) to describe the current practice of adapting NWB CT data after considering the WB state in LLR. The purpose of this study is to validate a new, standardized approach to include the WB state into the 3D planning and to compare this method against the current gold standard of 3D planning. Our hypothesis is that the correction is comparable to the gold standard, but shows less variability due compared to the more subjective hybrid approach.
Methods
Three surgical planning modalities were retrospectively analyzed in 43 legs scheduled for MOWHTO between 2015 and 2019. The planning modalities included: (1) 3D hybrid (3D non-weight-bearing (NWB) CT models after manual adaption of the opening angle considering the WB state in LLR, (2) 3D NWB (3D NWB CT models) and (3) 3D WB (2D/3D registration of 3D NWB CT models onto LLR to simulate the WB state). The pre- and postoperative hip-knee-ankle angle (HKA) and the planned opening angle (°) were assessed and differences among modalities reported. The relationship between the reported differences and BMI, preoperative HKA (LLR), medial meniscus extrusion, Outerbridge osteoarthritis grade and joint line convergence angle (JLCA) was analyzed.
Results
The mean (std) planned opening angle of 3D hybrid did not differ between 3D hybrid and 3D WB (0.4 ± 2.1°) (n.s.) but was higher in 3D hybrid compared to 3D NWB (1.1° ± 1.1°) ( p = 0.039). 3D WB demonstrated increased preoperative varus deformity compared to 3D NWB: 6.7 ± 3.8° vs. 5.6 ± 2.7° ( p = 0.029). Patients with an increased varus deformity in 3D WB compared to 3D NWB (> 2 °) demonstrated more extensive varus alignment in LLR ( p = 0.009) and a higher JLCA ( p = 0.013).
Conclusion
Small intermodal differences between the current practice of the reported 3D hybrid planning modality and a 3D WB approach using a 2D/3D registration algorithm were reported. In contrast, neglecting the WB state underestimates preoperative varus deformity and results in a smaller planned opening angle. This leads to potential under correction in MOWHTO, especially in patients with extensive varus deformities or JLCA. Clinical Relevance Incorporating the WB state in 3D planning modalities has the potential to increase accuracy and lead to a more consistent and reliable planning in MOWHTO. The inclusion of the WB state in automatized surgical planning algorithms has the potential to reduce costs and time in the future.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Stichwörter der Autor:innen
Autor:innen und Institutionen
- Balgrist University Hospital, Department of Orthopedics, University of Zurich, Forchstrasse 340, Zurich, 8008, Switzerland. sandro.hodel1@gmail.com.
- Balgrist University Hospital, Research in Orthopaedics Computer Science, University of Zurich, Balgrist Forchstrasse 340, Zurich, 8008, Switzerland.
- Balgrist University Hospital, Department of Orthopedics, University of Zurich, Forchstrasse 340, Zurich, 8008, Switzerland.
Förderung
- University of Zurich
Zitieren
APA
Hodel, S., Arn-Roth, T., Haug, F., Carillo, F., Vlachopoulos, L., Fucentese, S. F., & Fürnstahl, P. (2024). The influence of the weight-bearing state on three-dimensional (3D) planning in lower extremity realignment – analysis of novel vs. state-of-the-art planning approaches. Archives of Orthopaedic and Trauma Surgery. https://doi.org/10.1007/s00402-024-05289-3
Vancouver
Hodel S, Arn-Roth T, Haug F, Carillo F, Vlachopoulos L, Fucentese SF, et al. The influence of the weight-bearing state on three-dimensional (3D) planning in lower extremity realignment – analysis of novel vs. state-of-the-art planning approaches. Archives of Orthopaedic and Trauma Surgery. 2024. doi:10.1007/s00402-024-05289-3
BibTeX
@article{Hodel2024,
author = {Hodel, Sandro and Arn-Roth, Tabitha and Haug, Florian and Carillo, Fabio and Vlachopoulos, Lazaros and Fucentese, Sandro F and Fürnstahl, Philipp},
title = {The influence of the weight-bearing state on three-dimensional (3D) planning in lower extremity realignment – analysis of novel vs. state-of-the-art planning approaches},
journal = {Archives of Orthopaedic and Trauma Surgery},
year = {2024},
doi = {10.1007/s00402-024-05289-3}
}
EUVIMED