EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Influence of backward-facing steps on laminar-turbulent transition in two-dimensional boundary layers at subsonic Mach numbers

Steffen Risius, Marco Costantini

Experiments in Fluids · 2025-05 · 66 (5)

DOI: 10.1007/s00348-025-03994-2 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Experiments in Fluids, online erschienen am 09.04.2025. Verfasst von Steffen Risius und 1 weiteren Autor:innen. Die Arbeit wurde bisher 6-mal zitiert (Crossref) und nennt 63 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Deutsches Zentrum für Luft- und Raumfahrt e.V. (DLR).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Backward-facing steps (BFS) can have a detrimental impact on laminar flow lengths because of their strong effect on boundary layer transition. BFS with normalized step heights in the range of $$h/\delta _1 \approx$$ h / δ 1 ≈ 0.1 to 0.6 (corresponding to height-based Reynolds numbers of $$\hbox{Re}_h = (U_\infty h / \nu ) \approx$$ Re h = ( U ∞ h / ν ) ≈ 230 to 2430) were installed in a two-dimensional wind tunnel model and tested in the Cryogenic Ludwieg-Tube Göttingen, a blow-down wind tunnel with good flow quality. The influence of BFS on the location of laminar-turbulent transition was investigated over a wide range of unit Reynolds numbers from $$\hbox{Re}_1 = {17.5\times 10^{6}\,{\text {m}^{-1}}}$$ Re 1 = 17.5 × 10 6 m - 1 to $$80\times 10^{6}\,\hbox{m}^{-1}$$ 80 × 10 6 m - 1 , three Mach numbers, $$M= 0.35$$ M = 0.35 , 0.50 and 0.65, and various streamwise pressure gradients. The measurement of the transition locations was accomplished non-intrusively by means of temperature-sensitive paint. Transition Reynolds numbers, calculated with the flow length up to the location of laminar-turbulent transition $$x_{T}$$ x T , ranged from $$\hbox{Re}_{\rm tr}\approx$$ Re tr ≈ 1 × 10 6 to 11 × 10 6 , and were measured as a function of step height, pressure gradient, Reynolds and Mach numbers. Incompressible linear stability analysis was used to calculate amplification rates of Tollmien–Schlichting waves; transition N -factors were determined by correlation with the measured transition locations. In parallel to earlier investigations with a similar setup, this systematic approach was used to identify functional relations between non-dimensional step parameters ( $$h/\delta _1$$ h / δ 1 and $$\hbox{Re}_h$$ Re h ) and the relative change of the transition location. Furthermore, the change of the transition N -factor $$\Delta N$$ Δ N due to the installation of the steps was investigated. It was found that the installation of backward-facing steps with $$h/\delta _1 \lesssim 0.15$$ h / δ 1 ≲ 0.15 and $$\hbox{Re}_h \lesssim 300$$ Re h ≲ 300 does not lead to a reduction of $$\hbox{Re}_{\rm tr}$$ Re tr and to $$\Delta N > 0$$ Δ N > 0 . However, increasing the step size results in a decreasing laminar flow length and thus an increasing $$\Delta N$$ Δ N . The reported results are in general agreement with earlier investigations at significantly lower Mach and Reynolds numbers.

Förderung

  • Deutsches Zentrum für Luft- und Raumfahrt e.V. (DLR)

Zitieren

APA

Risius, S., & Costantini, M. (2025). Influence of backward-facing steps on laminar-turbulent transition in two-dimensional boundary layers at subsonic Mach numbers. Experiments in Fluids, 66(5). https://doi.org/10.1007/s00348-025-03994-2

Vancouver

Risius S, Costantini M. Influence of backward-facing steps on laminar-turbulent transition in two-dimensional boundary layers at subsonic Mach numbers. Experiments in Fluids. 2025;66(5). doi:10.1007/s00348-025-03994-2

BibTeX
@article{Risius2025,
  author = {Risius, Steffen and Costantini, Marco},
  title = {Influence of backward-facing steps on laminar-turbulent transition in two-dimensional boundary layers at subsonic Mach numbers},
  journal = {Experiments in Fluids},
  year = {2025},
  volume = {66},
  number = {5},
  doi = {10.1007/s00348-025-03994-2}
}
Kostenlos starten →