EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

A comparative characterisation of commercially available lipid-polymer nanoparticles formed from model membranes

Henry Sawczyc, Sabine Heit, Anthony Watts

European Biophysics Journal · 2023

DOI: 10.1007/s00249-023-01632-5 ↗

Kurz gefasst

Fachartikel in der Zeitschrift European Biophysics Journal, 2023. Verfasst von Henry Sawczyc und 2 weiteren Autor:innen. Beteiligte Einrichtung: Department of Biochemistry, University of Oxford, South Parks Road, Oxford, OX1 3QU, UK. henry.sawczyc@gmail.com. Hauptthemen laut MEDLINE: Polymers, Nanoparticles. Die Arbeit wurde bisher 6-mal zitiert (Crossref) und nennt 66 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Engineering and Physical Sciences Research Council.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

From the discovery of the first membrane-interacting polymer, styrene maleic-acid (SMA), there has been a rapid development of membrane solubilising polymers. These new polymers can solubilise membranes under a wide range of conditions and produce varied sizes of nanoparticles, yet there has been a lack of broad comparison between the common polymer types and solubilising conditions. Here, we present a comparative study on the three most common commercial polymers: SMA 3:1, SMA 2:1, and DIBMA. Additionally, this work presents, for the first time, a comparative characterisation of polymethacrylate copolymer (PMA). Absorbance and dynamic light scattering measurements were used to evaluate solubilisation across key buffer conditions in a simple, adaptable assay format that looked at pH, salinity, and divalent cation concentration. Lipid-polymer nanoparticles formed from SMA variants were found to be the most susceptible to buffer effects, with nanoparticles from either zwitterionic DMPC or POPC:POPG (3:1) bilayers only forming in low to moderate salinity (< 600 mM NaCl) and above pH 6. DIBMA-lipid nanoparticles could be formed above a pH of 5 and were stable in up to 4 M NaCl. Similarly, PMA-lipid nanoparticles were stable in all NaCl concentrations tested (up to 4 M) and a broad pH range (3–10). However, for both DIBMA and PMA nanoparticles there is a severe penalty observed for bilayer solubilisation in non-optimal conditions or when using a charged membrane. Additionally, lipid fluidity of the DMPC-polymer nanoparticles was analysed through cw-EPR, showing no cooperative gel-fluid transition as would be expected for native-like lipid membranes.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

PolymersNanoparticlesDimyristoylphosphatidylcholineSodium ChlorideLipid BilayersStyreneMaleatesLiposomes

Stichwörter der Autor:innen

DIBMALipid-polymer nanoparticlesLipodisqsNanodiscsPMASMALPs

Substanzen

PolymersDimyristoylphosphatidylcholineSodium ChlorideLipid BilayersStyreneMaleatesLipid NanoparticlesLiposomesmaleic acid

Autor:innen und Institutionen

  • Department of Biochemistry, University of Oxford, South Parks Road, Oxford, OX1 3QU, UK. henry.sawczyc@gmail.com.
  • Department of Biochemistry, University of Oxford, South Parks Road, Oxford, OX1 3QU, UK.
  • Department of Biochemistry, University of Oxford, South Parks Road, Oxford, OX1 3QU, UK. anthony.watts@bioch.ox.ac.uk.

Förderung

  • Engineering and Physical Sciences Research Council

Zitieren

APA

Sawczyc, H., Heit, S., & Watts, A. (2023). A comparative characterisation of commercially available lipid-polymer nanoparticles formed from model membranes. European Biophysics Journal. https://doi.org/10.1007/s00249-023-01632-5

Vancouver

Sawczyc H, Heit S, Watts A. A comparative characterisation of commercially available lipid-polymer nanoparticles formed from model membranes. European Biophysics Journal. 2023. doi:10.1007/s00249-023-01632-5

BibTeX
@article{Sawczyc2023,
  author = {Sawczyc, Henry and Heit, Sabine and Watts, Anthony},
  title = {A comparative characterisation of commercially available lipid-polymer nanoparticles formed from model membranes},
  journal = {European Biophysics Journal},
  year = {2023},
  doi = {10.1007/s00249-023-01632-5}
}
Kostenlos starten →