EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

A cross-method performance study: DOE-based regression, physics-based simulation, and sensor-based machine learning for injection molding quality prediction

Luke Shannon, Dhanashree Shinde, Sai Aditya Pradeep, Xiaoyi Liu, Hongpeng Yang, Xiangyu Hu, Yan Tong, Saeed Farahani

The International Journal of Advanced Manufacturing Technology · 21.11.2026

DOI: 10.1007/s00170-026-19582-5 ↗

Kurz gefasst

Fachartikel in der Zeitschrift The International Journal of Advanced Manufacturing Technology, online erschienen am 21.11.2026. Verfasst von Luke Shannon und 7 weiteren Autor:innen. Die Arbeit nennt 36 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Clemson University.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Quality monitoring in injection molding can be achieved through various modeling techniques, yet no clear framework exists to guide practitioners in selecting the most appropriate approach for their specific application requirements. Understanding which data sources and modeling strategies are needed, based on the required degree of accuracy, transparency, and cost constraints, remains an important and unresolved research gap in the industry. This study aims to address this challenge by presenting a comparative analysis of three predictive modeling methodologies for evaluating injection molded part quality, each representing a distinct level of complexity and cost: (1) multivariate regression modeling using design of experiments (DOE), the simplest and lowest-cost approach relying solely on machine data, which achieved an average MAPE of 0.95%; (2) physics-based simulation using Moldex3D, which requires commercial software licensing and performed well under normal fill conditions but was substantially penalized by short shot cycles that the simulation could not accurately represent, resulting in an average MAPE of 2.03%; and (3) machine learning (ML), utilizing a nested deep learning architecture based on long short-term memory (LSTM) networks, the most resource-intensive approach requiring in-mold sensors and data acquisition systems, which achieved an average MAPE of 0.27% on the selected comparison cycles, including short shots. These results highlight the complementary capabilities of the three modeling approaches: each approach addresses different needs along the manufacturing lifecycle, and the optimal selection depends on the balance of predictive accuracy, process coverage, and infrastructure cost.

Förderung

  • Clemson University

Zitieren

APA

Shannon, L., Shinde, D., Pradeep, S. A., Liu, X., Yang, H., Hu, X., Tong, Y., & Farahani, S. (2026). A cross-method performance study: DOE-based regression, physics-based simulation, and sensor-based machine learning for injection molding quality prediction. The International Journal of Advanced Manufacturing Technology. https://doi.org/10.1007/s00170-026-19582-5

Vancouver

Shannon L, Shinde D, Pradeep SA, Liu X, Yang H, Hu X, et al. A cross-method performance study: DOE-based regression, physics-based simulation, and sensor-based machine learning for injection molding quality prediction. The International Journal of Advanced Manufacturing Technology. 2026. doi:10.1007/s00170-026-19582-5

BibTeX
@article{Shannon2026,
  author = {Shannon, Luke and Shinde, Dhanashree and Pradeep, Sai Aditya and Liu, Xiaoyi and Yang, Hongpeng and Hu, Xiangyu and Tong, Yan and Farahani, Saeed},
  title = {A cross-method performance study: DOE-based regression, physics-based simulation, and sensor-based machine learning for injection molding quality prediction},
  journal = {The International Journal of Advanced Manufacturing Technology},
  year = {2026},
  doi = {10.1007/s00170-026-19582-5}
}
Kostenlos starten →