Chatter stability of boring bars incorporating fine particle dampers: effects of particle diameter and filling ratio on the maximum chatter-free length–diameter ratio
The International Journal of Advanced Manufacturing Technology · 2026-09 · 146 (5-6) · 3881-3895
DOI: 10.1007/s00170-026-18963-0 ↗Kurz gefasst
Fachartikel in der Zeitschrift The International Journal of Advanced Manufacturing Technology, online erschienen am 27.08.2026. Verfasst von Takashi Masutani und 4 weiteren Autor:innen. Die Arbeit nennt 36 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
Deep-hole boring requires a small shank diameter relative to the bore and a long overhang, which reduces boring-bar stiffness and often induces chatter, degrading surface roughness and tool life. Previous studies on boring bars incorporating particle dampers (PDs) have mainly examined relatively coarse particles. In the fine-particle regime, the effects of particle diameter and filling ratio on chatter stability in high- L / D (length–diameter ratio) boring have not yet been systematically clarified. To clarify these effects, PD boring bars were fabricated by drilling a blind hole in the rear end of a solid steel boring bar (shank diameter, 16 mm) and filling it with zirconia particles of nominal diameters 0.05, 0.10, 0.20, or 0.40 mm at prescribed filling ratios. Cutting tests were conducted, and the maximum chatter-free L / D was determined from machined surface observations. At a filling ratio of 58%, the maximum chatter-free L / D increased with decreasing particle diameter, reaching 7 for 0.05 mm particles, while solid steel and solid carbide boring bars of the same shank diameter yielded 4 and 5, respectively. For 0.05-mm particles, chatter-free cutting at L / D = 7 was achieved at filling ratios of 58% or higher while maintaining a non-compacted particle state. These results suggest a practical starting guideline under the investigated conditions: 0.05-mm-class particles with a filling ratio of at least 58%, while maintaining a non-compacted state. The feasibility of implementing this guideline via in-process powder encapsulation by laser powder bed fusion is also discussed.
Zitieren
APA
Masutani, T., Tsunoda, K., Tomita, S., Nakano, S., & Kataoka, R. (2026). Chatter stability of boring bars incorporating fine particle dampers: effects of particle diameter and filling ratio on the maximum chatter-free length–diameter ratio. The International Journal of Advanced Manufacturing Technology, 146(5-6), 3881-3895. https://doi.org/10.1007/s00170-026-18963-0
Vancouver
Masutani T, Tsunoda K, Tomita S, Nakano S, Kataoka R. Chatter stability of boring bars incorporating fine particle dampers: effects of particle diameter and filling ratio on the maximum chatter-free length–diameter ratio. The International Journal of Advanced Manufacturing Technology. 2026;146(5-6):3881-3895. doi:10.1007/s00170-026-18963-0
BibTeX
@article{Masutani2026,
author = {Masutani, Takashi and Tsunoda, Kan-ichi and Tomita, Sunao and Nakano, Sachito and Kataoka, Ryosuke},
title = {Chatter stability of boring bars incorporating fine particle dampers: effects of particle diameter and filling ratio on the maximum chatter-free length–diameter ratio},
journal = {The International Journal of Advanced Manufacturing Technology},
year = {2026},
volume = {146},
number = {5-6},
pages = {3881--3895},
doi = {10.1007/s00170-026-18963-0}
}
EUVIMED