EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Drop-like dross formation patterns and modes in laser cutting of stainless steel foils

Galing Tirtojati Suwito, Frank Brueckner, Alexander F.H. Kaplan

The International Journal of Advanced Manufacturing Technology · 2026-07 · 145 (5-6) · 3839-3854

DOI: 10.1007/s00170-026-18426-6 ↗

Kurz gefasst

Fachartikel in der Zeitschrift The International Journal of Advanced Manufacturing Technology, online erschienen am 27.06.2026. Verfasst von Galing Tirtojati Suwito und 2 weiteren Autor:innen. Die Arbeit nennt 39 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Lulea University of Technology.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The geometrical process conditions of thin foils in laser cutting result in higher local surface tension forces, increasing the susceptibility to dross attachment. Drop-like dross formation patterns and modes in laser cutting of 100 μm thin stainless steel foils were investigated using high-speed imaging and run length analysis. Laser power and cutting speed significantly influenced dross formation. Three distinct dross patterns were identified: an alternating side pattern, single-sided formation, and irregular formations on both sides. These patterns, observed via bottom-view high-speed imaging, correspond to the three melt flow modes A, S, and I respectively, each associated with different line energy regimes. Mode S tends to occur at low line energy, with about 3 ms duration until drop completion, while Mode A is more likely at high line energy, with about 18 ms completion time. A run length was introduced, where analysis revealed up to 36 consecutive dross deposits within the single-sided formation pattern. The preferred movement of the melt, either to the one or to the other cut edge, is based on details of the complex fluid mechanics, which could partially be explained, aided by high-speed imaging. Occasional drop merging events were observed during single-sided formation when molten dross remained in contact with a newly formed drop before solidification. Dross diameter and kerf width were measured, as key criteria for controlled laser cutting. These findings offer new insights into how process parameters govern dross behavior in thin-sheet laser cutting, aiming to keep one side dross-free.

Förderung

  • Lulea University of Technology

Zitieren

APA

Suwito, G. T., Brueckner, F., & Kaplan, A. F. (2026). Drop-like dross formation patterns and modes in laser cutting of stainless steel foils. The International Journal of Advanced Manufacturing Technology, 145(5-6), 3839-3854. https://doi.org/10.1007/s00170-026-18426-6

Vancouver

Suwito GT, Brueckner F, Kaplan AF. Drop-like dross formation patterns and modes in laser cutting of stainless steel foils. The International Journal of Advanced Manufacturing Technology. 2026;145(5-6):3839-3854. doi:10.1007/s00170-026-18426-6

BibTeX
@article{Suwito2026,
  author = {Suwito, Galing Tirtojati and Brueckner, Frank and Kaplan, Alexander F.H.},
  title = {Drop-like dross formation patterns and modes in laser cutting of stainless steel foils},
  journal = {The International Journal of Advanced Manufacturing Technology},
  year = {2026},
  volume = {145},
  number = {5-6},
  pages = {3839--3854},
  doi = {10.1007/s00170-026-18426-6}
}
Kostenlos starten →