EUVIMEDEUVIMED entdecken
Crossref

Alloying Interphase Engineering of Reusable MOF‐Based Solid Electrolyte for Ultrastable Lithium Metal Anodes

Wen-Qing Wang, Xiang Li, Zheshuai Lin, Yue Li, Jian-Hua Cao, Da-Yong Wu iD

Small · 2026-02 · 22 (7)

DOI: 10.1002/smll.202512376 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Small, online erschienen am 12.12.2025. Verfasst von Wen-Qing Wang und 5 weiteren Autor:innen. Beteiligte Einrichtung: Technical Institute of Physics and Chemistry, Chinese Academy of Sciences, Beijing, 100190, China. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 58 Literaturangaben. Gefördert von: National Key R&D Pilot Project "Research and development of high temperature resistant, long life, and high safety lithium batteries".

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Coating the separator surface of high‐energy‐density lithium batteries with a solid‐state inorganic ion conductor can enhance the ionic conductivity and lithium‐ion transference number, while improving interfacial contact between the separator and electrodes. However, during battery cycling, high‐valence metal ions in the solid‐state ion conductor are prone to reduction by metallic lithium, leading to performance degradation. In this study, the applicability of inorganic solid‐state electrolytes, such as Li 1 . 3 Al 0 . 3 Ti 1 . 7 (PO 4 ) 3 (LATP), compounded with Ag‐MOF on the lithium metal anode side is investigated. Experimental results demonstrate that a composite separator with an Ag‐MOF:LATP mass ratio of 8:92, when assembled in Li||Li symmetric cells, exhibits stable cycling for over 1200 h at 0.5 mA cm −2 . Furthermore, in NCM811||Li batteries, after 300 cycles at 0.5C and 500 cycles at 5C, the capacity retention rates remain at 70.9% and 76.1%, respectively. The functional mechanism of Ag‐MOF involves formation of an Ag‐Li alloy during cycling, which suppresses Ti⁴⁺ reduction and enhances cycling stability. The most significant finding is that the disassembled composite separator can be reused for two additional charge‐discharge cycles after battery cycling, exhibiting outstanding reusability with a capacity retention rate consistently exceeding 70% after 500 cycles at 5C rate.

Schlagwörter

Stichwörter der Autor:innen

Ag‐Li alloysLATP/Li interfacelithium metal batteriesseparator reusabilitysynergistic transmission

Autor:innen und Institutionen

  • Technical Institute of Physics and Chemistry, Chinese Academy of Sciences, Beijing, 100190, China.
  • University of Chinese Academy of Sciences, Beijing, 100049, China.

ORCID-Profile: Da-Yong Wu

Förderung

  • National Key R&D Pilot Project "Research and development of high temperature resistant, long life, and high safety lithium batteries"

Zitieren

APA

Wang, W. Q., Li, X., Lin, Z., Li, Y., Cao, J. H., & Wu, D. Y. (2026). Alloying Interphase Engineering of Reusable MOF‐Based Solid Electrolyte for Ultrastable Lithium Metal Anodes. Small, 22(7). https://doi.org/10.1002/smll.202512376

Vancouver

Wang WQ, Li X, Lin Z, Li Y, Cao JH, Wu DY. Alloying Interphase Engineering of Reusable MOF‐Based Solid Electrolyte for Ultrastable Lithium Metal Anodes. Small. 2026;22(7). doi:10.1002/smll.202512376

BibTeX
@article{Wang2026,
  author = {Wang, Wen-Qing and Li, Xiang and Lin, Zheshuai and Li, Yue and Cao, Jian-Hua and Wu, Da-Yong},
  title = {Alloying Interphase Engineering of Reusable MOF‐Based Solid Electrolyte for Ultrastable Lithium Metal Anodes},
  journal = {Small},
  year = {2026},
  volume = {22},
  number = {7},
  doi = {10.1002/smll.202512376}
}
Kostenlos starten →