EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC-ND 4.0

Enhanced Electrocatalytic and Cathode‐Electrolyte Interfacial Properties With a Pr‐Based Simple Perovskite/Ruddlesden‐Popper Nanocomposite Cathode in Protonic Ceramic Fuel Cells

Ryo Kitamura, Eric Yoshida, Talia Marie Sebastian, Yuchen Zhang, Minda Zou, Jiawei Zhang, Ted Burye, Zeyu Zhao iD, Dong Ding, Kai He, Jianhua Tong iD

Small · 2026-03 · 22 (13)

DOI: 10.1002/smll.202510995 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Small, online erschienen am 14.01.2026. Verfasst von Ryo Kitamura und 10 weiteren Autor:innen. Beteiligte Einrichtung: Department of Materials Science and Engineering, Clemson University, Clemson, South Carolina, USA. Die Arbeit wurde bisher 10-mal zitiert (Crossref) und nennt 77 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0). Gefördert von: US Army DEVCOM Ground Vehicle Systems Center, Clemson University's Virtual Prototyping of Autonomy Enabled Ground Systems (VIPR-GS), National Science Foundation, National Science Foundation Graduate Research Fellowship Program.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The sluggish kinetics and poor stability of the oxygen reduction reaction (ORR) remain the primary bottleneck for achieving high performance in protonic ceramic fuel cells (PCFCs) at intermediate temperatures (400–650°C). In this work, a Pr‐based nanocomposite cathode comprised of simple perovskite phase (PrNi 0.7 Co 0.3 O 3‐δ ) and Ruddlesden‐Popper phase (Co‐doped Pr 4 Ni 3 O 10+δ ) is developed. Although PrNi 0.7 Co 0.3 O 3‐δ solely stands as a good cathode with facile proton transfer, combining the superior catalytic activity against oxygen on the Ruddlesden‐Popper phase boosts the ORR performance further. The designed nanocomposite cathode outperforms the simple perovskite cathode, attributed to enhanced oxygen absorption and surface diffusion with the Ruddlesden‐Popper phase. A precursor‐based cathode deposition technique is also developed to achieve cathode grain sizes of ∼100 nm. A single cell with the nanocomposite cathode delivers a peak power density of 1.38 W cm −2 at 650°C, among the highest in reported PCFCs with Pr‐based cathodes, with a small degradation rate of 0.145 mV h −1 during 250 h stability test. Further investigation of cathode‐electrolyte interface revealed interfacial PrO 2 phase formation, promoted by abundant Pr 6 O 11 in the nanocomposite precursor powder, thereby improving both ohmic resistance and stability. These findings highlight the effectiveness of the nanocomposite cathode and underscore its advantages on interfacial properties.

Schlagwörter

Stichwörter der Autor:innen

Ruddlesden‐Popper phasecatalytic electrodecathodesnanocompositesone‐pot sol–gel synthesisperovskiteprotonic ceramic fuel cell

Autor:innen und Institutionen

  • Department of Materials Science and Engineering, Clemson University, Clemson, South Carolina, USA.
  • Department of Materials Science and Engineering, University of California, Irvine, California, USA.
  • Ground Vehicle Systems Center (GVSC), Detroit, Michigan, USA.
  • Energy & Environmental Science and Technology, Idaho National Laboratory, Idaho Falls, Idaho, USA.

ORCID-Profile: Zeyu Zhao, Jianhua Tong

Förderung

  • US Army DEVCOM Ground Vehicle Systems Center, Clemson University's Virtual Prototyping of Autonomy Enabled Ground Systems (VIPR-GS)
  • National Science Foundation
  • National Science Foundation Graduate Research Fellowship Program
  • University of California Irvine Materials Research Institute
  • National Science Foundation Materials Research Science and Engineering Center program
  • University of California Irvine Center for Complex and Active Materials
  • Hydrogen and Fuel Cell Technologies Office
  • Basic Energy Sciences

Zitieren

APA

Kitamura, R., Yoshida, E., Sebastian, T. M., Zhang, Y., Zou, M., Zhang, J., Burye, T., Zhao, Z., Ding, D., He, K., & Tong, J. (2026). Enhanced Electrocatalytic and Cathode‐Electrolyte Interfacial Properties With a Pr‐Based Simple Perovskite/Ruddlesden‐Popper Nanocomposite Cathode in Protonic Ceramic Fuel Cells. Small, 22(13). https://doi.org/10.1002/smll.202510995

Vancouver

Kitamura R, Yoshida E, Sebastian TM, Zhang Y, Zou M, Zhang J, et al. Enhanced Electrocatalytic and Cathode‐Electrolyte Interfacial Properties With a Pr‐Based Simple Perovskite/Ruddlesden‐Popper Nanocomposite Cathode in Protonic Ceramic Fuel Cells. Small. 2026;22(13). doi:10.1002/smll.202510995

BibTeX
@article{Kitamura2026,
  author = {Kitamura, Ryo and Yoshida, Eric and Sebastian, Talia Marie and Zhang, Yuchen and Zou, Minda and Zhang, Jiawei and Burye, Ted and Zhao, Zeyu and Ding, Dong and He, Kai and Tong, Jianhua},
  title = {Enhanced Electrocatalytic and Cathode‐Electrolyte Interfacial Properties With a Pr‐Based Simple Perovskite/Ruddlesden‐Popper Nanocomposite Cathode in Protonic Ceramic Fuel Cells},
  journal = {Small},
  year = {2026},
  volume = {22},
  number = {13},
  doi = {10.1002/smll.202510995}
}
Kostenlos starten →