EUVIMEDEUVIMED entdecken
Crossref

DC Reactive‐Sputtered NiO X Hole Transport Layers with Tailored Nickel Vacancies for Perovskite Single‐Junction and Textured Perovskite/Silicon Tandem Solar Cells

Yuan Luo, Sihan Li, Rui Xia, Xianzhao Wang, Biao Shi, Wei Han, Pengfei Liu, Ye Xu, Xueling Zhang, Yifeng Chen, Jifan Gao, Shuangbiao Xia und 5 weitere

Small · 2025-10 · 21 (40)

DOI: 10.1002/smll.202506247 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Small, online erschienen am 19.08.2025. Verfasst von Yuan Luo und 16 weiteren Autor:innen. Beteiligte Einrichtung: Institute of Photoelectronic Thin Film Devices and Technology, Renewable Energy Conversion and Storage Center, State Key Laboratory of Photovoltaic M…. Die Arbeit wurde bisher 7-mal zitiert (Crossref) und nennt 48 Literaturangaben. Gefördert von: National Key Research and Development Program of China, National Natural Science Foundation Joint Fund, National Science Foundation.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Sputtered nickel oxide (NiO X ) is a promising material for hole transport layers (HTLs) in industrializing perovskite solar cells (PSCs) due to its scalable and conformal growth. However, its low conductivity and interfacial instability limit device performance. Herein, high‐quality undoped NiO X (DC‐N) HTLs are developed fabricated via direct current (DC) reactive sputtering (Ni target) coupled with low‐temperature (≤ 200 °C) air annealing. By synergistically modulating process conditions, nickel vacancy density is tailoreded to balance photoelectric properties and interfacial stability of DC‐N HTLs, while elucidating trade‐offs among conductivity, transmittance, and interfacial stability. Contrastive analysis reveals that the DC‐N HTLs outperform conventional RF‐sputtered NiO X HTLs (derived from ceramic targets, doped or undoped), mainly attributed to their outstanding conductivity, an ideal Ni 3+ /Ni 2+ ratio, good crystallization, and excellent interface properties, which mitigate parasitic absorption, recombination losses, and charge transport losses. By employing DC‐N HTLs, inverted PSCs with a 1.68 eV bandgap achieve a power conversion efficiency (PCE) of 20.71%, increasing to 22.45% with Me‐4PACz/Al 2 O 3 interlayers and thick‐film perovskite. Notably, integrating DC‐N HTLs into textured perovskite/silicon tandem solar cells delivered a PCE of 32.02% (1.0 cm 2 aperture area), providing valuable insights for NiO X ‐based tandem photovoltaics.

Schlagwörter

Stichwörter der Autor:innen

inverted perovskite solar cellsnickel oxidesnickel vacanciesreactive sputteringtextured perovskite/silicon tandem solar cells

Autor:innen und Institutionen

  • Institute of Photoelectronic Thin Film Devices and Technology, Renewable Energy Conversion and Storage Center, State Key Laboratory of Photovoltaic Materials and Cells, Nankai University, Tianjin, 300350, P. R. China.
  • Tianjin Key Laboratory of Efficient Utilization of Solar Energy, Tianjin, 300350, P. R. China.
  • Haihe Laboratory of Sustainable Chemical Transformations, Tianjin, 300192, P. R. China.
  • Engineering Research Center of Thin Film Photoelectronic Technology of Ministry of Education, Tianjin, 300350, P. R. China.
  • State Key Laboratory of PV Science and Technology, Trina Solar, Changzhou, 210031, P. R. China.
  • Research Center for New Energy Technology (RCNET), State Key Laboratory of Materials for Integrated Circuits, Shanghai Institute of Microsystem and Information Technology, Chinese Academy of Sciences (CAS), Changning, S…

ORCID-Profile: Xiaodan Zhang

Förderung

  • National Key Research and Development Program of China
  • National Natural Science Foundation Joint Fund
  • National Science Foundation
  • Yunnan Provincial Science and Technology Project at Southwest United Graduate School
  • China Higher Education Discipline Innovation Overseas Expert Introduction Project
  • Tianjin Science and Technology Project
  • China Postdoctoral Science Foundation
  • Haihe Laboratory of Sustainable Chemical Transformations

Zitieren

APA

Luo, Y., Li, S., Xia, R., Wang, X., Shi, B., Han, W., Liu, P., Xu, Y., Zhang, X., Chen, Y., Gao, J., Xia, S., Wang, Y., Zhang, L., Wang, P., Zhao, Y., & Zhang, X. (2025). DC Reactive‐Sputtered NiO X Hole Transport Layers with Tailored Nickel Vacancies for Perovskite Single‐Junction and Textured Perovskite/Silicon Tandem Solar Cells. Small, 21(40). https://doi.org/10.1002/smll.202506247

Vancouver

Luo Y, Li S, Xia R, Wang X, Shi B, Han W, et al. DC Reactive‐Sputtered NiO X Hole Transport Layers with Tailored Nickel Vacancies for Perovskite Single‐Junction and Textured Perovskite/Silicon Tandem Solar Cells. Small. 2025;21(40). doi:10.1002/smll.202506247

BibTeX
@article{Luo2025,
  author = {Luo, Yuan and Li, Sihan and Xia, Rui and Wang, Xianzhao and Shi, Biao and Han, Wei and Liu, Pengfei and Xu, Ye and Zhang, Xueling and Chen, Yifeng and Gao, Jifan and Xia, Shuangbiao and Wang, Yutao and Zhang, Liping and Wang, Pengyang and Zhao, Ying and Zhang, Xiaodan},
  title = {DC Reactive‐Sputtered NiO X Hole Transport Layers with Tailored Nickel Vacancies for Perovskite Single‐Junction and Textured Perovskite/Silicon Tandem Solar Cells},
  journal = {Small},
  year = {2025},
  volume = {21},
  number = {40},
  doi = {10.1002/smll.202506247}
}
Kostenlos starten →