EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC 4.0

Enhanced Cycling Stability of NCM811 Cathodes at High C‐Rates and Voltages via LiMTFSI‐Based Polymer Coating

Hori Kim, Moon-Ki Jeong, Hyuk-Joon Kim, Youngsin Kim, Kisuk Kang, Joon Hak Oh iD

Small · 2025-07 · 21 (30)

DOI: 10.1002/smll.202502816 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Small, online erschienen am 28.05.2025. Verfasst von Hori Kim und 5 weiteren Autor:innen. Beteiligte Einrichtung: School of Chemical and Biological Engineering and Institute of Chemical Processes, Seoul National University, 1 Gwanak-ro, Gwanak-gu, Seoul, 08826, R…. Die Arbeit wurde bisher 16-mal zitiert (Crossref) und nennt 62 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC 4.0). Gefördert von: National Research Foundation of Korea (NRF), Ministry of Science and ICT (MSIT), Korea, Seoul National University.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Improving the cycling stability in Ni‐rich LiNi x Co y Mn 1−x−y O 2 (NCM) cathodes, particularly under high C‐rates and elevated voltages, remains a significant challenge in lithium battery technology. A novel polymer coating based on lithium sulfonyl(trifluoromethane sulfonyl)imide methacrylate (LiMTFSI), a material commonly used in solid polymer electrolytes (SPEs), is applied to LiNi 0.8 Co 0.1 Mn 0.1 O 2 (NCM811) cathodes. This coating improves electrochemical stability at high C‐rates (2C and 4C) and voltages up to 4.5 V, compared to uncoated cathodes, enabling reduced charging times (e.g., 1 h at 1C to 15 min at 4C) while maintaining relatively enhanced cycling performance. Mechanistically, the coating helps suppress surface phase transitions to the rock‐salt phase, mitigates transition metal dissolution, and facilitates lithium‐ion transport at the cathode–electrolyte interface. These combined effects contribute to enhanced cycling durability under demanding conditions. Galvanostatic intermittent titration technique (GITT) analysis further supports that the coating promotes interfacial lithium‐ion conduction without acting as an insulating barrier. Additionally, the coated NCM811 electrodes exhibit improved rate performance. This study shows that repurposing SPE‐derived monomers as cathode surface modifiers provides a practical route to improving rapid‐charging capability, energy utilization, and long‐term operational stability in lithium batteries.

Schlagwörter

Stichwörter der Autor:innen

LiNi0.8Co0.1Mn0.1O2cycling stabilityphase transitionssurface coatingstransition metal dissolution

Autor:innen und Institutionen

  • School of Chemical and Biological Engineering and Institute of Chemical Processes, Seoul National University, 1 Gwanak-ro, Gwanak-gu, Seoul, 08826, Republic of Korea.
  • Department of Materials Science and Engineering, Research Institute of Advanced Materials (RIAM), Seoul National University, 1 Gwanak-ro, Gwanak-gu, Seoul, 151-742, Republic of Korea.
  • Center for Nanoparticle Research, Institute for Basic Science (IBS), Seoul National University, 1 Gwanak-ro, Gwanak-gu, Seoul, 151-742, Republic of Korea.
  • Institute for Rechargeable Battery Innovations, Seoul National University, 1 Gwanak-ro, Gwanak-gu, Seoul, 08826, Republic of Korea.

ORCID-Profile: Joon Hak Oh

Förderung

  • National Research Foundation of Korea (NRF)
  • Ministry of Science and ICT (MSIT), Korea
  • Seoul National University

Zitieren

APA

Kim, H., Jeong, M. K., Kim, H. J., Kim, Y., Kang, K., & Oh, J. H. (2025). Enhanced Cycling Stability of NCM811 Cathodes at High C‐Rates and Voltages via LiMTFSI‐Based Polymer Coating. Small, 21(30). https://doi.org/10.1002/smll.202502816

Vancouver

Kim H, Jeong MK, Kim HJ, Kim Y, Kang K, Oh JH. Enhanced Cycling Stability of NCM811 Cathodes at High C‐Rates and Voltages via LiMTFSI‐Based Polymer Coating. Small. 2025;21(30). doi:10.1002/smll.202502816

BibTeX
@article{Kim2025,
  author = {Kim, Hori and Jeong, Moon-Ki and Kim, Hyuk-Joon and Kim, Youngsin and Kang, Kisuk and Oh, Joon Hak},
  title = {Enhanced Cycling Stability of NCM811 Cathodes at High C‐Rates and Voltages via LiMTFSI‐Based Polymer Coating},
  journal = {Small},
  year = {2025},
  volume = {21},
  number = {30},
  doi = {10.1002/smll.202502816}
}
Kostenlos starten →