EUVIMEDEUVIMED entdecken
Open Access

Enhanced Electrostatic Dust Removal from Solar Panels Using Transparent Conductive Nano‐Textured Surfaces

Fabian J Dickhardt iD, Sreedath Panat, Kripa K Varanasi iD

Small · 2025-01 · 21 (3)

DOI: 10.1002/smll.202408645 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Small, online erschienen am 02.12.2024. Verfasst von Fabian J Dickhardt und 2 weiteren Autor:innen. Beteiligte Einrichtung: Department of Mechanical Engineering, Massachusetts Institute of Technology, 127 Massachusetts Avenue, Cambridge, MA, 02142, USA. Die Arbeit wurde bisher 15-mal zitiert (Crossref) und nennt 55 Literaturangaben. Der Volltext ist frei in PubMed Central verfügbar. Gefördert von: Eni S.p.A..

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Dust accumulation on solar panels is a mjor operational challenge faced by the photovoltaic industry. Removing dust using water‐based cleaning is expensive and unsustainable. Dust repulsion via charge induction is an efficient way to clean solar panels and recover power output without consuming any water. However, it is still challenging to remove particles of ≈30 µm and smaller because Van der Waals force of adhesion dominates electrostatic force of repulsion. Here, the study proposes nano‐textured, transparent, electrically conductive glass surfaces to significantly enhance electrostatic dust removal for particles smaller than ≈30 µm. We perform atomic force microscopy pull‐off force experiments and demonstrates that nano‐textured surfaces reduce the force of adhesion of silica micro‐particles by up to 2 orders of magnitude compared to un‐textured surfaces from 460 to 8.6 nN. We show that reduced adhesion on nano‐textured surfaces results in significantly better dust removal of small particles compared to non‐textured or micro‐textured surfaces, reducing the surface coverage from 35% to 10%. We fabricate transparent, electrically conductive, nano‐textured glass that can be retrofitted on solar panel surfaces using copper nano‐mask based scalable nano‐fabrication technique and shows that 90% of lost power output for particles smaller than ≈10 µm can be recovered.

Schlagwörter

Stichwörter der Autor:innen

Van der Waals adhesionelectrostatic dust removalnano‐textured glassparticle adhesionphotovoltaicssustainability

Autor:innen und Institutionen

  • Department of Mechanical Engineering, Massachusetts Institute of Technology, 127 Massachusetts Avenue, Cambridge, MA, 02142, USA.

ORCID-Profile: Fabian J Dickhardt, Kripa K Varanasi

Förderung

  • Eni S.p.A.

Zitieren

APA

Dickhardt, F. J., Panat, S., & Varanasi, K. K. (2025). Enhanced Electrostatic Dust Removal from Solar Panels Using Transparent Conductive Nano‐Textured Surfaces. Small, 21(3). https://doi.org/10.1002/smll.202408645

Vancouver

Dickhardt FJ, Panat S, Varanasi KK. Enhanced Electrostatic Dust Removal from Solar Panels Using Transparent Conductive Nano‐Textured Surfaces. Small. 2025;21(3). doi:10.1002/smll.202408645

BibTeX
@article{Dickhardt2025,
  author = {Dickhardt, Fabian J and Panat, Sreedath and Varanasi, Kripa K},
  title = {Enhanced Electrostatic Dust Removal from Solar Panels Using Transparent Conductive Nano‐Textured Surfaces},
  journal = {Small},
  year = {2025},
  volume = {21},
  number = {3},
  doi = {10.1002/smll.202408645}
}
Kostenlos starten →