Interfacial Engineering of Nickel Oxide‐Perovskite Interface with Amino Acid Complexed NiO to Improve Perovskite Solar Cell Performance
Small · 2024-12 · 20 (49)
DOI: 10.1002/smll.202405953 ↗Kurz gefasst
Fachartikel in der Zeitschrift Small, online erschienen am 20.09.2024. Verfasst von Dilpreet Singh Mann und 5 weiteren Autor:innen. Beteiligte Einrichtung: Department of Flexible and Printable Electronics and LANL-JBNU Engineering Institute-Korea, Jeonbuk National University, 567, Baekje-daero, Deokjin-g…. Die Arbeit wurde bisher 27-mal zitiert (Crossref) und nennt 111 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Basic Science Research Program through the National Research Foundation of Korea funded by the Ministry of Education, Open R&D Program of Korea Electric Power Corporation.
Abstract (Originalsprache)
The interface between NiO and perovskite in inverted perovskite solar cells (PSCs) is a major factor that can limit device performance due to defects and inappropriate redox reactions, which cause nonradiative recombination and decrease in open‐circuit voltage (VOC). In the present study, a novel approach is used for the first time, where an amino acid (glycine (Gly), alanine (Ala), and aminobutyric acid (ABA))‐complexed NiO are used as interface modifiers to eliminate defect sites and hydroxyl groups from the surface of NiO. The Ala‐complexed NiO suppresses interfacial non‐radiative recombination, improves the perovskite layer quality and better energy band alignment with the perovskite, resulting in improved charge transfer and reduced recombination. The incorporation of the Ala‐complexed NiO leads to a PCE of 20.27% with enhanced stability under the conditions of ambient air, light soaking, and heating to 85 °C, as it retains over 82%, 85%, and 61% of its initial PCE after 1000, 500, and 350 h, respectively. The low‐temperature technique also leads to the fabrication of a NiO thin film that is suitable for flexible PSCs. The Ala‐complexed NiO is fabricated on the flexible substrate and achieved 17.12% efficiency while retaining 71% of initial PCE after 5,000 bending.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- Department of Flexible and Printable Electronics and LANL-JBNU Engineering Institute-Korea, Jeonbuk National University, 567, Baekje-daero, Deokjin-gu, Jeonju-si, 54896, Republic of Korea.
- Department of Polymer-Nano Science and Technology, Department of Nano Convergence Engineering, Jeonbuk National University, 567, Baekje-daero, Deokjin-gu, Jeonju-si, 54896, Republic of Korea.
ORCID-Profile: Seok-In Na
Förderung
- Basic Science Research Program through the National Research Foundation of Korea funded by the Ministry of Education
- Open R&D Program of Korea Electric Power Corporation
Zitieren
APA
Mann, D. S., Thakur, S., Sangale, S. S., Jeong, K. U., Kwon, S. N., & Na, S. I. (2024). Interfacial Engineering of Nickel Oxide‐Perovskite Interface with Amino Acid Complexed NiO to Improve Perovskite Solar Cell Performance. Small, 20(49). https://doi.org/10.1002/smll.202405953
Vancouver
Mann DS, Thakur S, Sangale SS, Jeong KU, Kwon SN, Na SI. Interfacial Engineering of Nickel Oxide‐Perovskite Interface with Amino Acid Complexed NiO to Improve Perovskite Solar Cell Performance. Small. 2024;20(49). doi:10.1002/smll.202405953
BibTeX
@article{Mann2024,
author = {Mann, Dilpreet Singh and Thakur, Sakshi and Sangale, Sushil S and Jeong, Kwang-Un and Kwon, Sung-Nam and Na, Seok-In},
title = {Interfacial Engineering of Nickel Oxide‐Perovskite Interface with Amino Acid Complexed NiO to Improve Perovskite Solar Cell Performance},
journal = {Small},
year = {2024},
volume = {20},
number = {49},
doi = {10.1002/smll.202405953}
}
EUVIMED