EUVIMEDEUVIMED entdecken
Crossref

Polycarbonate‐Based Solid‐Polymer Electrolytes for Solid‐State Sodium Batteries

Erick Ruoff, Steven Kmiec, Arumugam Manthiram iD

Small · 2024-06 · 20 (24)

DOI: 10.1002/smll.202311839 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Small, online erschienen am 28.12.2023. Verfasst von Erick Ruoff und 2 weiteren Autor:innen. Beteiligte Einrichtung: Materials Science and Engineering Program & Texas Materials Institute, The University of Texas at Austin, Austin, Texas, 78712, USA. Die Arbeit wurde bisher 16-mal zitiert (Crossref) und nennt 55 Literaturangaben. Gefördert von: U.S. Department of Energy, Basic Energy Sciences, Division of Materials Sciences and Engineering.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Solid‐polymer electrolytes comprised of polypropylene carbonate (PPC) and varied sodium bis(fluorosulfonyl)imide (NaFSI) salt concentrations are investigated for implementation as a conductive solid polymer electrolyte into solid‐state cathode composites utilizing a sodium‐layered oxide active material. The ionic conductivity generally increases with NaFSI salt content, reaching ≈1 mS cm −1 at 80 °C at the highest salt concentration (PPC:NaFSI = 0.5:1). Through an all‐in‐one slurry casting method, Na 2/3 Ni 1/3 Mn 2/3 O 2 cathode composites are fabricated in which the dispersed PPC electrolyte acts as the primary binder. Enabled by a bilayer polymer electrolyte system, cycling performance with the PPC cathode electrolyte is optimized with respect to salt concentration and anode material. The best cyclability is achieved with a moderate salt concentration electrolyte (PPC:NaFSI = 5:1), showcasing an initial capacity of 83 mA h g −1 with a remarkable 80% capacity retention after 150 cycles at C/5 rate and 60 °C. The superior performance of the lower salt concentration electrolyte is attributed to better electrochemical stability, as confirmed by linear sweep voltammetry and online electrochemical mass spectrometry measurements. These results underscore the potential of carbonate‐based polymer electrolytes and the importance of balancing electrolyte conductivity and stability in cell design.

Schlagwörter

Stichwörter der Autor:innen

electrochemistrylayered oxide cathodesodium metalsodium‐tin anodesolid polymer electrolytesolid‐state battery

Autor:innen und Institutionen

  • Materials Science and Engineering Program & Texas Materials Institute, The University of Texas at Austin, Austin, Texas, 78712, USA.

ORCID-Profile: Arumugam Manthiram

Förderung

  • U.S. Department of Energy
  • Basic Energy Sciences
  • Division of Materials Sciences and Engineering

Zitieren

APA

Ruoff, E., Kmiec, S., & Manthiram, A. (2024). Polycarbonate‐Based Solid‐Polymer Electrolytes for Solid‐State Sodium Batteries. Small, 20(24). https://doi.org/10.1002/smll.202311839

Vancouver

Ruoff E, Kmiec S, Manthiram A. Polycarbonate‐Based Solid‐Polymer Electrolytes for Solid‐State Sodium Batteries. Small. 2024;20(24). doi:10.1002/smll.202311839

BibTeX
@article{Ruoff2024,
  author = {Ruoff, Erick and Kmiec, Steven and Manthiram, Arumugam},
  title = {Polycarbonate‐Based Solid‐Polymer Electrolytes for Solid‐State Sodium Batteries},
  journal = {Small},
  year = {2024},
  volume = {20},
  number = {24},
  doi = {10.1002/smll.202311839}
}
Kostenlos starten →