EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC-ND 4.0

Rapid and simple determination of average molecular weight and composition of synthetic polymers via electrospray ionization‐mass spectrometry and a Bayesian universal charge deconvolution

Addie R Keating, Chrys Wesdemiotis iD

Rapid Communications in Mass Spectrometry · 30.04.2023 · 37 (8)

DOI: 10.1002/rcm.9478 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Rapid Communications in Mass Spectrometry, online erschienen am 19.02.2023. Verfasst von Addie R Keating und 1 weiteren Autor:innen. Beteiligte Einrichtung: Department of Chemistry, The University of Akron, Akron, Ohio, USA. Die Arbeit wurde bisher 8-mal zitiert (Crossref) und nennt 44 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0). Gefördert von: National Science Foundation.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Rationale

Simple, affordable, and rapid methods for identifying the molecular weight (MW) distribution and macromolecular composition of polymeric materials are limited. Current tools require extensive solvent consumption, linear calibrations, and expensive consumables. A simple method for the determination of average MW ( M n , M w ) and chain end groups is demonstrated for synthetic homopolymer standards using direct injection electrospray ionization‐mass spectrometry (ESI‐MS) and an open‐sourced charge deconvolution (CDC) algorithm.

Methods

Five homopolymer standards in the 1–7 kDa MW range were analyzed using direct‐injection ESI‐MS on a quadrupole/time‐of‐flight mass spectrometer. The samples investigated, viz. two poly(ethylene oxide) (PEO) and two poly(styrene sulfonic acid) (PSS) standards with narrow polydispersity and one poly( d , l ‐alanine) (pAla) standard with undefined polydispersity, were chosen to illustrate challenges with ESI‐MS quantitation. Using the UniDec program, weight average MWs ( M w ) obtained from the charge‐deconvoluted spectra were compared to the reported M w data of the standards from size exclusion chromatography (SEC) measurements.

Results

The MW data derived for the PSS, PEO, and pAla standards agreed well with the corresponding reported M w or MW range values. The method was able to provide MW, degree of polymerization (DP), and polydispersity index (PDI) information for polymers with narrow (PSS, PEO) as well as broader (pAla) molecular weight distribution; this feature provides an advantage over MW analysis via matrix‐assisted laser desorption/ionization (MALDI) for ESI‐compatible materials. PSS standards differing in average MW by only a few repeat units could be confidently distinguished. Additionally, the oligomeric resolution observed for all samples studied unveiled chain‐end information not available through chromatographic analysis.

Conclusions

Overall, the free and easy‐to‐use UniDec CDC algorithm provides a simple, alternative method to measuring MW and DP for polymeric materials without high solvent consumption, expensive ionization sources, or calibration curves. Information about the masses of individual oligomers and the possibility to further characterize these oligomers using tandem mass spectrometry and/or ion mobility techniques constitutes additional benefits of this approach vis‐à‐vis traditional MW and PDI elucidation through SEC.

Autor:innen und Institutionen

  • Department of Chemistry, The University of Akron, Akron, Ohio, USA.
  • School of Polymer Science and Polymer Engineering, The University of Akron, Akron, Ohio, USA.

ORCID-Profile: Chrys Wesdemiotis

Förderung

  • National Science Foundation

Zitieren

APA

Keating, A. R., & Wesdemiotis, C. (2023). Rapid and simple determination of average molecular weight and composition of synthetic polymers via electrospray ionization‐mass spectrometry and a Bayesian universal charge deconvolution. Rapid Communications in Mass Spectrometry, 37(8). https://doi.org/10.1002/rcm.9478

Vancouver

Keating AR, Wesdemiotis C. Rapid and simple determination of average molecular weight and composition of synthetic polymers via electrospray ionization‐mass spectrometry and a Bayesian universal charge deconvolution. Rapid Communications in Mass Spectrometry. 2023;37(8). doi:10.1002/rcm.9478

BibTeX
@article{Keating2023,
  author = {Keating, Addie R and Wesdemiotis, Chrys},
  title = {Rapid and simple determination of average molecular weight and composition of synthetic polymers via electrospray ionization‐mass spectrometry and a Bayesian universal charge deconvolution},
  journal = {Rapid Communications in Mass Spectrometry},
  year = {2023},
  volume = {37},
  number = {8},
  doi = {10.1002/rcm.9478}
}
Kostenlos starten →