EUVIMEDEUVIMED entdecken
Crossref

Ion Useful Yields and Matrix Effects in 26 Al– 26 Mg Dating by Secondary Ion Mass Spectrometry

Nozomu Makino iD, Noriyuki Kawasaki iD, Toru Matsumoto iD, Naoya Sakamoto

Rapid Communications in Mass Spectrometry · 15.06.2026 · 40 (11)

DOI: 10.1002/rcm.70056 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Rapid Communications in Mass Spectrometry, online erschienen am 12.03.2026. Verfasst von Nozomu Makino und 3 weiteren Autor:innen. Beteiligte Einrichtung: Department of Earth and Planetary Sciences, Faculty of Science, Hokkaido University, Sapporo, Japan. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 38 Literaturangaben. Gefördert von: Japan Society for the Promotion of Science, JGC-Saneyoshi Scholarship Foundation.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Rationale

Secondary ion mass spectrometry (SIMS) has been widely applied to 26 Al– 26 Mg dating of the earliest Solar System solids. Both 16 O − and 16 O 2 − primary beams have been used for such analyses, yet the influence of primary ion beam species on secondary ion useful yields and matrix effects has not been systematically evaluated. A better understanding of these effects is essential for improving the accuracy and precision of 26 Al– 26 Mg dating.

Methods

For standard materials used in 26 Al– 26 Mg dating, we determined sputter rates, useful yields, and matrix effects on the relative sensitivity factors (RSFs) of 27 Al/ 24 Mg and the instrumental mass fractionations (IMFs) of Mg isotopes under the 16 O − and 16 O 2 − primary beam conditions using SIMS. The sputter rates were evaluated using a rastered beam, whereas the other parameters were obtained under the actual analytical conditions employed for 26 Al– 26 Mg dating.

Results

The 16 O 2 − primary beam condition generally provided higher useful yields than the 16 O − condition, except for anorthite and melilite analyzed under low ion current conditions. Variations in RSFs among samples of the same mineral species but with different compositions were either larger or smaller between the 16 O − and 16 O 2 − conditions, depending on the mineral species, whereas IMF variations tended to be slightly larger under the 16 O 2 − condition than under the 16 O − condition.

Conclusions

Our results highlight the necessity of carefully evaluating useful yields, along with the behaviors of RSF and IMF, when optimizing analytical conditions for SIMS‐based 26 Al– 26 Mg dating, as well as for other isotopic systems that can be analyzed using SIMS.

Schlagwörter

Stichwörter der Autor:innen

26Al–26Mg datinginstrumental mass fractionationrelative sensitivity factorsecondary ion mass spectrometryuseful yield

Autor:innen und Institutionen

  • Department of Earth and Planetary Sciences, Faculty of Science, Hokkaido University, Sapporo, Japan.
  • The Hakubi Center for Advanced Research, Kyoto University, Kyoto, Japan.
  • Division of Earth and Planetary Sciences, Kyoto University, Kyoto, Japan.
  • Institute for Integrated Innovations, Hokkaido University, Sapporo, Japan.

ORCID-Profile: Nozomu Makino, Noriyuki Kawasaki, Toru Matsumoto

Förderung

  • Japan Society for the Promotion of Science
  • JGC-Saneyoshi Scholarship Foundation

Zitieren

APA

Makino, N., Kawasaki, N., Matsumoto, T., & Sakamoto, N. (2026). Ion Useful Yields and Matrix Effects in 26 Al– 26 Mg Dating by Secondary Ion Mass Spectrometry. Rapid Communications in Mass Spectrometry, 40(11). https://doi.org/10.1002/rcm.70056

Vancouver

Makino N, Kawasaki N, Matsumoto T, Sakamoto N. Ion Useful Yields and Matrix Effects in 26 Al– 26 Mg Dating by Secondary Ion Mass Spectrometry. Rapid Communications in Mass Spectrometry. 2026;40(11). doi:10.1002/rcm.70056

BibTeX
@article{Makino2026,
  author = {Makino, Nozomu and Kawasaki, Noriyuki and Matsumoto, Toru and Sakamoto, Naoya},
  title = {Ion Useful Yields and Matrix Effects in 26 Al– 26 Mg Dating by Secondary Ion Mass Spectrometry},
  journal = {Rapid Communications in Mass Spectrometry},
  year = {2026},
  volume = {40},
  number = {11},
  doi = {10.1002/rcm.70056}
}
Kostenlos starten →