Exploring Alternative Methods for Determining the Recoverable Creep Compliance of Polymer Melts
Journal of Polymer Science · 25.07.2026
DOI: 10.1002/pola.70276 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Polymer Science, online erschienen am 25.07.2026. Verfasst von Montgomery T. Shaw und 1 weiteren Autor:innen. Die Arbeit nennt 14 Literaturangaben.
Abstract (Originalsprache)
The limiting, steady‐state, recoverable compliance is the basic measure of the elasticity of polymer melts. Although normally measured using a creep experiment, there are alternative viscoelastic measurements that might be more convenient or even less prone to error. The purpose of this work was to examine these alternatives for practicality and error, using polymer melts. While melts are often studied because of their commercial importance, melts are chosen here for simplicity: no concerns about solvent loss, phase separation or safety issues. The major test polymer used was a linear low‐density polyethylene (LLDPE) with a trade name of LDPE‐6201 (Union Carbide). As extrapolation is required for all methods, one expects discrepancies and such were found. At least with a stress‐controlled rheometer, the traditional method (creep) appears to be optimal, although some long times are required to reduce extrapolation error. A dynamic method was found to be simple to run and quite reproducible, but the found value of was higher by ~7%. This discrepancy will be examined in future work.
Zitieren
APA
Shaw, M. T., & Weiss, R. A. (2026). Exploring Alternative Methods for Determining the Recoverable Creep Compliance of Polymer Melts. Journal of Polymer Science. https://doi.org/10.1002/pola.70276
Vancouver
Shaw MT, Weiss RA. Exploring Alternative Methods for Determining the Recoverable Creep Compliance of Polymer Melts. Journal of Polymer Science. 2026. doi:10.1002/pola.70276
BibTeX
@article{Shaw2026,
author = {Shaw, Montgomery T. and Weiss, Robert A.},
title = {Exploring Alternative Methods for Determining the Recoverable Creep Compliance of Polymer Melts},
journal = {Journal of Polymer Science},
year = {2026},
doi = {10.1002/pola.70276}
}
EUVIMED