EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC-ND 4.0

Development of a laser‐assisted fused deposition modeling process for improvement in bond tensile strength of ABS

Hrudaya J. Biswal, Marshall Metcalf, Cristina Stefanescu, Peter Lucon

Journal of Polymer Science · 2024-06 · 62 (11) · 2503-2514

DOI: 10.1002/pol.20230926 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Polymer Science, online erschienen am 15.03.2024. Verfasst von Hrudaya J. Biswal und 3 weiteren Autor:innen. Die Arbeit wurde bisher 15-mal zitiert (Crossref) und nennt 25 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0). Gefördert von: DEVCOM Army Research Laboratory.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Fused deposition modeling (FDM), an advanced 3D printing method, is a rapidly growing technology for realizing geometrically complex parts. FDM utilizes a thermoplastic feedstock that is heated and extruded through a nozzle to build up layers of material following toolpaths prescribed by three‐dimensional (3D) data. However, the rapid thermal cycles that the material undergoes during this process limit the formation, growth, and entanglement of the molecular chains in the material. Herein, we have proposed a novel laser‐assisted fused deposition modeling (LAFDM) process for the improvement in printed part properties such as bond width and tensile strength. The LAFDM system was developed consisting of an infrared laser, coupled with an industrial FDM printer. Using an adapted tensile testing method, the bond strength between deposited layers of acrylonitrile butadiene styrene (ABS) in 3D‐printed structures was assessed. Thermogravimetric analysis was used to monitor the thermal stability of the polymer to detect alterations to the chemical composition of the material as a result of the processing conditions. A 9.5% increase in the average bond tensile strength for the LAFDM‐printed specimen was observed compared to that of the non‐laser‐assisted FDM‐printed specimen. The improvement to the bond strengths was achieved without compromising the thermal stability of the polymer.

Förderung

  • DEVCOM Army Research Laboratory

Zitieren

APA

Biswal, H. J., Metcalf, M., Stefanescu, C., & Lucon, P. (2024). Development of a laser‐assisted fused deposition modeling process for improvement in bond tensile strength of ABS. Journal of Polymer Science, 62(11), 2503-2514. https://doi.org/10.1002/pol.20230926

Vancouver

Biswal HJ, Metcalf M, Stefanescu C, Lucon P. Development of a laser‐assisted fused deposition modeling process for improvement in bond tensile strength of ABS. Journal of Polymer Science. 2024;62(11):2503-2514. doi:10.1002/pol.20230926

BibTeX
@article{Biswal2024,
  author = {Biswal, Hrudaya J. and Metcalf, Marshall and Stefanescu, Cristina and Lucon, Peter},
  title = {Development of a laser‐assisted fused deposition modeling process for improvement in bond tensile strength of ABS},
  journal = {Journal of Polymer Science},
  year = {2024},
  volume = {62},
  number = {11},
  pages = {2503--2514},
  doi = {10.1002/pol.20230926}
}
Kostenlos starten →