Tensile properties of banana fiber reinforced recycled high‐density polyethylene composites: An experimental investigation
SPE Polymers · 2024-07 · 5 (3) · 306-317
DOI: 10.1002/pls2.10125 ↗Kurz gefasst
Fachartikel in der Zeitschrift SPE Polymers, online erschienen am 28.02.2024. Verfasst von Md. Syduzzaman und 7 weiteren Autor:innen. Die Arbeit wurde bisher 21-mal zitiert (Crossref) und nennt 51 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
Natural fiber‐reinforced polymer composites (NFRCs) are increasingly favored over synthetic fiber‐reinforced alternatives due to their beneficial properties and environmental sustainability. Mechanical properties of composites are critical to ensure optimized utilization of NFRCs. Here, this research explores the effects of different fiber parameters on the tensile strength of high‐density polymer composites reinforced with banana fiber and utilizes the Taguchi method for both experimental and statistical analysis of the outcomes. Three different parameters are considered here: weight fractions, fiber orientation angle, and plasma treatment to fabricate the composites using the compression molding process. Taguchi analysis revealed that fiber orientation angle has the greatest influence among the three variables, with plasma treatment and weight fraction following in impact on tensile strength. The composite that exhibited the highest tensile strength was determined to have a weight fraction of 10%, a fiber orientation angle of 90°, and a plasma treatment period of 5 min. This combination yielded a strength of 30.351 MPa. The analysis of the interaction between any two factors was done using contour plots. In order to compare the experimental tensile strength values with the anticipated values derived from the regression equation, regression analysis was carried out. Highlights Composites were made up of recycled HDPE (rHDPE) from plastic bottles using a compression molding technique. The Taguchi method is applied to achieve an experimental design employing an L4 orthogonal array. Contour plot analysis is conducted to identify points of minimum and maximum responses, as anticipated from the results. Tensile strength was optimized to a maximum of 30.351 MPa.
Zitieren
APA
Syduzzaman, M., Akter, M., Mahmud, F., Bhowmick, D. R., Maliha, A. S., Fahmi, F. F., Hossain, T., & Ahamed, M. A. (2024). Tensile properties of banana fiber reinforced recycled high‐density polyethylene composites: An experimental investigation. SPE Polymers, 5(3), 306-317. https://doi.org/10.1002/pls2.10125
Vancouver
Syduzzaman M, Akter M, Mahmud F, Bhowmick DR, Maliha AS, Fahmi FF, et al. Tensile properties of banana fiber reinforced recycled high‐density polyethylene composites: An experimental investigation. SPE Polymers. 2024;5(3):306-317. doi:10.1002/pls2.10125
BibTeX
@article{Syduzzaman2024,
author = {Syduzzaman, Md. and Akter, Mahin and Mahmud, Foysal and Bhowmick, Diti Rani and Maliha, Afia Sultana and Fahmi, Fahmida Faiza and Hossain, Tanvir and Ahamed, Md. Ahasan},
title = {Tensile properties of banana fiber reinforced recycled high‐density polyethylene composites: An experimental investigation},
journal = {SPE Polymers},
year = {2024},
volume = {5},
number = {3},
pages = {306--317},
doi = {10.1002/pls2.10125}
}
EUVIMED