EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC-ND 4.0

Experimental Validation of Prediction Models of Pressure‐Throughput Behavior for Melt‐Conveying Elements in Fully Intermeshing Co‐Rotating Twin‐Screw Extruders

Jakub Kuncak, Ursula Steiner, Alexander Hammer, Gerald Berger‐Weber

Polymer Engineering & Science · 02.11.2026

DOI: 10.1002/pen.70978 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Polymer Engineering & Science, online erschienen am 02.11.2026. Verfasst von Jakub Kuncak und 3 weiteren Autor:innen. Die Arbeit nennt 19 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0). Gefördert von: Österreichische Forschungsförderungsgesellschaft.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Modeling and simulation of the melt conveying of co‐rotating twin screw extruders, one of the important manufacturing machines in polymer processing, is commonly done by means of generalized, dimensionless models. Recently, novel general hybrid models have been published, which combine physics‐based approaches with extensive simulation and machine learning. This article experimentally validates the pressure‐throughput behavior prediction of these models for four different polymer grades, three screw element geometries and a large range of extruder setpoints. An automated data processing evaluates the data, resulting here in an average prediction error of 7.3%, and showing a close agreement between the models and the measurements. However, subsequent uncertainty analysis shows that large measurement noise raises the mean uncertainty of the processed experimental data to 14.5%. Furthermore, we show that the experimental results exhibit large sensitivity to fluctuations in viscosity, which is further very sensitive to temperature and assumes a constant representative shear rate. Most operating points suffer from having a wide‐range temperature distribution across the melt channel, which is shown by numerically finding representative cup‐mixing temperature using the Monte Carlo approach. Despite these limitations, the results demonstrate the hybrid models to agree well with experimental data and outperform existing analytical modeling frameworks.

Förderung

  • Österreichische Forschungsförderungsgesellschaft

Zitieren

APA

Kuncak, J., Steiner, U., Hammer, A., & Berger‐Weber, G. (2026). Experimental Validation of Prediction Models of Pressure‐Throughput Behavior for Melt‐Conveying Elements in Fully Intermeshing Co‐Rotating Twin‐Screw Extruders. Polymer Engineering & Science. https://doi.org/10.1002/pen.70978

Vancouver

Kuncak J, Steiner U, Hammer A, Berger‐Weber G. Experimental Validation of Prediction Models of Pressure‐Throughput Behavior for Melt‐Conveying Elements in Fully Intermeshing Co‐Rotating Twin‐Screw Extruders. Polymer Engineering & Science. 2026. doi:10.1002/pen.70978

BibTeX
@article{Kuncak2026,
  author = {Kuncak, Jakub and Steiner, Ursula and Hammer, Alexander and Berger‐Weber, Gerald},
  title = {Experimental Validation of Prediction Models of Pressure‐Throughput Behavior for Melt‐Conveying Elements in Fully Intermeshing Co‐Rotating Twin‐Screw Extruders},
  journal = {Polymer Engineering & Science},
  year = {2026},
  doi = {10.1002/pen.70978}
}
Kostenlos starten →