EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Manufacturing of Single‐Material Sandwich Structures via Vacuum‐Assisted Rotational Foam Molding for Lightweight Applications

Aryan Oktaee, Jannik Werner, Dietmar Drummer

Polymer Engineering & Science · 20.11.2026

DOI: 10.1002/pen.70899 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Polymer Engineering & Science, online erschienen am 20.11.2026. Verfasst von Aryan Oktaee und 2 weiteren Autor:innen. Die Arbeit nennt 27 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Deutsche Bundesstiftung Umwelt.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Economic and environmental sustainability are driving the demand for material‐efficient and lightweight polymer structures. This study presents a new one‐shot process strategy for manufacturing single‐material sandwich structures by vacuum‐assisted rotational foam molding. The influence of vacuum pressure on the morphology and mechanical properties of the foamed structures was investigated using microscopy, computed tomography (CT), density measurements, and ring stiffness testing, while the influence of processing temperature on the melt fraction was determined experimentally. The results show that lower vacuum pressures promote pore coalescence, leading to larger and less uniform pores within the foamed core layer. Increasing the fraction of the foamed layer generally reduced density, although excessive coalescence could counteract this effect. Furthermore, pore morphology was found to significantly influence mechanical performance independent of density. The specimen produced at 40 mbar exhibited substantially higher ring stiffness than the specimen produced at 80 mbar despite comparable densities and layer distributions, which can be attributed to differences in foam morphology. The developed process enables the production of lightweight single‐material sandwich structures with tailored pore morphologies and mechanical properties. These findings demonstrate the potential of vacuum‐assisted rotational foam molding to tailor foam morphology and mechanical performance in single‐material sandwich structures, thereby supporting the development of more sustainable lightweight polymer components without the use of chemical blowing agents.

Förderung

  • Deutsche Bundesstiftung Umwelt

Zitieren

APA

Oktaee, A., Werner, J., & Drummer, D. (2026). Manufacturing of Single‐Material Sandwich Structures via Vacuum‐Assisted Rotational Foam Molding for Lightweight Applications. Polymer Engineering & Science. https://doi.org/10.1002/pen.70899

Vancouver

Oktaee A, Werner J, Drummer D. Manufacturing of Single‐Material Sandwich Structures via Vacuum‐Assisted Rotational Foam Molding for Lightweight Applications. Polymer Engineering & Science. 2026. doi:10.1002/pen.70899

BibTeX
@article{Oktaee2026,
  author = {Oktaee, Aryan and Werner, Jannik and Drummer, Dietmar},
  title = {Manufacturing of Single‐Material Sandwich Structures via Vacuum‐Assisted Rotational Foam Molding for Lightweight Applications},
  journal = {Polymer Engineering & Science},
  year = {2026},
  doi = {10.1002/pen.70899}
}
Kostenlos starten →