EUVIMEDEUVIMED entdecken
Crossref

Improving the surface quality of material extrusion additive manufacturing parts by using ultrasonic‐vibration machining

S. Jiang, K. Hu, X. Huang, C. Zhao

Polymer Engineering & Science · 2023-08 · 63 (8) · 2613-2623

DOI: 10.1002/pen.26399 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Polymer Engineering & Science, online erschienen am 16.06.2023. Verfasst von S. Jiang und 3 weiteren Autor:innen. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 32 Literaturangaben. Gefördert von: National Natural Science Foundation of China.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Material extrusion (ME) technique has been one of the most popular additive manufacturing techniques because of its environmental friendliness, low cost, simple operation, and so forth. However, significant surface defects occur on ME parts due to the discontinuity between adjacent layers. For this reason, a new method, using ultrasonic‐vibration machining, was innovatively proposed to improve the ME parts' surface quality. A theoretical surface roughness (SR) model of the ME parts processed by using ultrasonic vibration was established. An ultrasonic‐vibrating ME equipment was then set up by refitting an ordinary one and the samples built without and with ultrasonic‐vibration machining utilized were prepared, respectively. With the laser microscope, the built parts' SR was tested and determined. Compared the predicted SR results with the measured ones, the theoretical model was verified. The influence of different ultrasonic vibration on the surface quality of ME parts was also discussed, clarifying the corresponding mechanism.

Förderung

  • National Natural Science Foundation of China

Zitieren

APA

Jiang, S., Hu, K., Huang, X., & Zhao, C. (2023). Improving the surface quality of material extrusion additive manufacturing parts by using ultrasonic‐vibration machining. Polymer Engineering & Science, 63(8), 2613-2623. https://doi.org/10.1002/pen.26399

Vancouver

Jiang S, Hu K, Huang X, Zhao C. Improving the surface quality of material extrusion additive manufacturing parts by using ultrasonic‐vibration machining. Polymer Engineering & Science. 2023;63(8):2613-2623. doi:10.1002/pen.26399

BibTeX
@article{Jiang2023,
  author = {Jiang, S. and Hu, K. and Huang, X. and Zhao, C.},
  title = {Improving the surface quality of material extrusion additive manufacturing parts by using ultrasonic‐vibration machining},
  journal = {Polymer Engineering & Science},
  year = {2023},
  volume = {63},
  number = {8},
  pages = {2613--2623},
  doi = {10.1002/pen.26399}
}
Kostenlos starten →