EUVIMEDEUVIMED entdecken
Crossref

Mechanical Properties and Fracture Characteristics of Multi‐Structured 2.5D Angle‐Interlock Woven Composites

Lei Chen, Tao Yang, Jianhui Pi, Jiaqing Liu

Polymer Composites · 20.01.2026 · 47 (2) · 1693-1706

DOI: 10.1002/pc.70245 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Polymer Composites, online erschienen am 29.07.2025. Verfasst von Lei Chen und 3 weiteren Autor:innen. Die Arbeit wurde bisher 5-mal zitiert (Crossref) und nennt 36 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Five types of 2. 5D angle‐interlock woven preforms were fabricated, namely fiber‐only warp ( FOW ), shallow interlaced curved weft ( SICW ), SICW with reinforcing warp yarns ( SICW ‐ RW ), shallow interlaced straight weft ( SISW ), and SISW with reinforcing warp yarns ( SISW ‐ RW ), to investigate their mechanical performance differences under warp‐direction tensile and four‐point bending loads. Tensile test results indicate that the warp‐reinforced structures significantly enhance the warp‐direction load‐bearing capacity, with the average ultimate load of SICW ‐ RW and SISW ‐ RW increasing by 38.6% and 33.9%, respectively, compared to SICW and SISW . The stress–strain distribution shown by the Digital Image Correlation ( DIC ) technique indicates that the warp‐reinforced design helps reduce the overall strain level. Bending test results show that SICW ‐ RW and SISW ‐ RW exhibit increases in ultimate load by 67.9% and 20.9%, respectively, demonstrating improved bending strength. The influence of different weft structures on fracture morphology and mechanical properties shows that the straight interlaced structure, with a 10% reduction in weft yarns, exhibits superior tensile and bending properties compared to the curved interlaced structure, although its fracture morphology is more irregular. The curved interlaced structure has a higher weft yarn content, which enhances the lateral confinement, resulting in a smoother fracture surface. Although the FOW structure exhibits the highest tensile strength, its bending strength is the lowest due to the lack of weft yarn support, making the fibers in localized areas prone to stress concentration and resulting in single‐point failure.

Zitieren

APA

Chen, L., Yang, T., Pi, J., & Liu, J. (2026). Mechanical Properties and Fracture Characteristics of Multi‐Structured 2.5D Angle‐Interlock Woven Composites. Polymer Composites, 47(2), 1693-1706. https://doi.org/10.1002/pc.70245

Vancouver

Chen L, Yang T, Pi J, Liu J. Mechanical Properties and Fracture Characteristics of Multi‐Structured 2.5D Angle‐Interlock Woven Composites. Polymer Composites. 2026;47(2):1693-1706. doi:10.1002/pc.70245

BibTeX
@article{Chen2026,
  author = {Chen, Lei and Yang, Tao and Pi, Jianhui and Liu, Jiaqing},
  title = {Mechanical Properties and Fracture Characteristics of Multi‐Structured 2.5D Angle‐Interlock Woven Composites},
  journal = {Polymer Composites},
  year = {2026},
  volume = {47},
  number = {2},
  pages = {1693--1706},
  doi = {10.1002/pc.70245}
}
Kostenlos starten →