Modification of Hydrotalcite Loading Tannic Acid with Organic Silane and Application in Anticorrosive Epoxy Coating
ChemistryOpen · 2024-10 · 13 (10)
DOI: 10.1002/open.202400120 ↗Kurz gefasst
Fachartikel in der Zeitschrift ChemistryOpen, online erschienen am 28.06.2024. Verfasst von Bui Minh Quy und 8 weiteren Autor:innen. Beteiligte Einrichtung: Thai Nguyen University of Sciences, Thai Nguyen University, Tan Thinh, Thai Nguyen, Vietnam. Die Arbeit wurde bisher 8-mal zitiert (Crossref) und nennt 67 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Vietnam Academy of Science and Technology.
Abstract (Originalsprache)
Metal corrosion is a challenge for the world with heavy impacts on the economy. Study on the development of effectiveness anticorrosion additives is a promising strategery for the protection industry. This research focuses on the modification of hydrotalcite Mg−Al (HT) loading tannic acid (TA) with 3‐(trimethoxy silyl) propyl methacrylate organo‐silane (TMSPM) for applicating as an anti‐corrosion additive for epoxy coating on the steel substrate. The suitable ratio of HT and modifiers was investigated and the suitable content of modified HT in epoxy matrix was found based on mechanical properties of the epoxy‐based coating. The characteristics of modified HT were assessed through infrared (IR) spectroscopy, X‐ray diffraction pattern (XRD), scanning electron microscopy (SEM), thermal gravimetry analysis (TGA), water contact angle (WCA), dynamic light scattering (DLS). Detailly, HT‐TA3‐S3 shows good stability in distilled water when HT/TA was modified with TMSPM which makes Zeta potential decreases significantly. Besides, SEM analysis presented HT‐TA‐S has a cylindrical shape about of 500 nm. Moreover, the crystallite size of HT/TA after being modified by TMSPM decreases sharply. All of these prove successfully synthesize HT loading TA with modified TMSPM. Water contact angle (WCA) decreases in case of loading TA and increases in case of modifying with TMSPM (WCA changed from HT (116.3°) to HT‐TA (102.4°) and HT‐TA‐S (120.1°) which indicates the increased hydrophobicity of the sample. The obtained results showed HT/TA was modified successfully with TMSPM. The modification affected the size distribution and surface properties of HT nanoparticles while it did not impact on the crystal structure of HT. After incorporating modified HT/TA into the epoxy coating, the adhesion of coating to steel substrate was improved significantly. Consequently, the adhesion of epoxy/3 wt. % modified HT/TA coating was increased 3 times as compared to epoxy neat (from 0.76 MPa to 2.77 MPa). In addition, the relative hardness and gloss retention of epoxy/3 wt. % modified HT/TA coating reached the maximum values as compared to the others. Owing to salt spraying results, the epoxy/3 wt. % modified HT/TA exhibited an excellent anticorrosion ability for the steel substrate. All the above results show the potential of HT nanoparticles loading TA modified with TMSPM as anticorrosive additives for protective coatings on steel substrates.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- Thai Nguyen University of Sciences, Thai Nguyen University, Tan Thinh, Thai Nguyen, Vietnam.
- Institute for Tropical Technology, Vietnam Academy of Science and Technology, 18 Hoang Quoc Viet, Cau Giay, Ha Noi, Vietnam.
- Graduate University of Science and Technology, Vietnam Academy of Science and Technology, 18 Hoang Quoc Viet, Cau Giay, Ha Noi, Vietnam.
- Faculty of Chemistry, Hanoi National University of Education, 136 Xuan Thuy, Cau Giay, Ha Noi, Vietnam.
- Institute of Environmental Sciences, Nguyen Tat Thanh University, Ward 13, District 4, Ho Chi Minh, Vietnam.
- Hong Ha Shipbuilding Company, Km 17+300 National Highway, Le Thien Commune, An Duong District, Hai Phong, Vietnam.
ORCID-Profile: Nguyen Thuy Chinh
Förderung
- Vietnam Academy of Science and Technology
Zitieren
APA
Quy, B. M., Chinh, N. T., Anh, N. T. K., Tuyet, V. T., Thai, N. X., Trung, V. Q., Quyen, N. T. C., Tan, N. N., & Hoang, T. (2024). Modification of Hydrotalcite Loading Tannic Acid with Organic Silane and Application in Anticorrosive Epoxy Coating. ChemistryOpen, 13(10). https://doi.org/10.1002/open.202400120
Vancouver
Quy BM, Chinh NT, Anh NTK, Tuyet VT, Thai NX, Trung VQ, et al. Modification of Hydrotalcite Loading Tannic Acid with Organic Silane and Application in Anticorrosive Epoxy Coating. ChemistryOpen. 2024;13(10). doi:10.1002/open.202400120
BibTeX
@article{Quy2024,
author = {Quy, Bui Minh and Chinh, Nguyen Thuy and Anh, Nguyen Thi Kim and Tuyet, Vu Thi and Thai, Nguyen Xuan and Trung, Vu Quoc and Quyen, Ngo Thi Cam and Tan, Nguyen Ngoc and Hoang, Thai},
title = {Modification of Hydrotalcite Loading Tannic Acid with Organic Silane and Application in Anticorrosive Epoxy Coating},
journal = {ChemistryOpen},
year = {2024},
volume = {13},
number = {10},
doi = {10.1002/open.202400120}
}
EUVIMED