EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Polypropylene Copolymers Designed for Fused Filament Fabrication 3D‐Printing

Gunnar Spiegel, Christian Paulik

Macromolecular Reaction Engineering · 2020-02 · 14 (1)

DOI: 10.1002/mren.201900044 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Macromolecular Reaction Engineering, online erschienen am 08.01.2020. Verfasst von Gunnar Spiegel und 1 weiteren Autor:innen. Die Arbeit wurde bisher 20-mal zitiert (Crossref) und nennt 17 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Österreichische Forschungsförderungsgesellschaft.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Several chemical properties which influence the printability for fused filament fabrication 3D‐printing are derived from analyses of commercially available filaments. In preliminary experiments, polymerization conditions are optimized and suitable monomers and selectivity control agents (donors) are selected. An experimental series in which propene is copolymerized with the comonomers 1‐butene and 1‐hexene with an industrial Ziegler–Natta catalyst will be discussed here. The experiments are planned using design of experiments. Based on a split‐plot design, the design is adapted for mixtures and the combination of homo‐ and copolymerization. The observed factors, besides the mixture composition, are hydrogen partial pressure and the amount of donor. The obtained polymers are analyzed by means of high‐temperature size exclusion chromatography, differential scanning calorimetry, and rheology. 1‐Butene copolymers show good printing results and promising properties almost matching the desired ones. The targeted polymer properties are achieved within certain limits. 1‐Hexene copolymers result in lower molecular masses while crystallinity remains slightly higher, which does not match with the desired profile. Beneficial properties are likely to be achieved within a wider factor range, for example, higher comonomer amount and lower hydrogen partial pressure.

Förderung

  • Österreichische Forschungsförderungsgesellschaft

Zitieren

APA

Spiegel, G., & Paulik, C. (2020). Polypropylene Copolymers Designed for Fused Filament Fabrication 3D‐Printing. Macromolecular Reaction Engineering, 14(1). https://doi.org/10.1002/mren.201900044

Vancouver

Spiegel G, Paulik C. Polypropylene Copolymers Designed for Fused Filament Fabrication 3D‐Printing. Macromolecular Reaction Engineering. 2020;14(1). doi:10.1002/mren.201900044

BibTeX
@article{Spiegel2020,
  author = {Spiegel, Gunnar and Paulik, Christian},
  title = {Polypropylene Copolymers Designed for Fused Filament Fabrication 3D‐Printing},
  journal = {Macromolecular Reaction Engineering},
  year = {2020},
  volume = {14},
  number = {1},
  doi = {10.1002/mren.201900044}
}
Kostenlos starten →