EUVIMEDEUVIMED entdecken
Crossref

3D‐Printed Continuous Composite GRIN Media for Millimeter‐Wave Lenses in V‐ and W‐Band

Wei Wang, Bradley Duncan, Patrick Bluem, Devon Beck, Roberto Rojas, Jonathan Chisum

Microwave and Optical Technology Letters · 2026-11 · 68 (11)

DOI: 10.1002/mop.70851 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Microwave and Optical Technology Letters, online erschienen am 06.11.2026. Verfasst von Wei Wang und 5 weiteren Autor:innen. Die Arbeit nennt 40 Literaturangaben. Gefördert von: Office of the Under Secretary of Defense.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This paper presents a novel 3D printing technique that generates continuous composite Gradient Refractive Index (GRIN) filaments, suitable for the realization of low‐profile GRIN lenses in the V‐ and W‐band. By controlling the volumetric ratio of two materials at the print‐head, the effective permittivity of the 3D printing filament can be instantly engineered during fabrication over a range of 2.0–8.3. Unlike most 3D‐printed GRIN media where a variation in the effective permittivity must be realized by printing a small unit‐cell with a prescribed volume ratio of dielectric (the filament) and air, this approach uses a continuous filament where the permittivity is defined in real‐time at the print head. As such, the frequency limit is set by the filament width, not the lattice constant of a unit‐cell. Because the ceramic loading is mixed into the polymer matrix at a scale far smaller than the wavelength, the printed filament is treated as an effective bulk medium rather than as a resonant artificial dielectric. This approach is promising for future applications in V‐band, W‐band, and beyond. The method is demonstrated with a 50 mm flat GRIN lens prototype measured from across the V‐ and W‐bands, ranging from 70 to 90 GHz, with the gain increasing from 18 to 22 dB. The measured radiation efficiency is between 65% and 72% across the band, confirming that the printed filament has low‐loss at high‐frequency and that there is no GRIN frequency cutoff in the band. These results suggest that 3D composite inks are good candidates for high‐frequency GRIN lens manufacturing.

Förderung

  • Office of the Under Secretary of Defense

Zitieren

APA

Wang, W., Duncan, B., Bluem, P., Beck, D., Rojas, R., & Chisum, J. (2026). 3D‐Printed Continuous Composite GRIN Media for Millimeter‐Wave Lenses in V‐ and W‐Band. Microwave and Optical Technology Letters, 68(11). https://doi.org/10.1002/mop.70851

Vancouver

Wang W, Duncan B, Bluem P, Beck D, Rojas R, Chisum J. 3D‐Printed Continuous Composite GRIN Media for Millimeter‐Wave Lenses in V‐ and W‐Band. Microwave and Optical Technology Letters. 2026;68(11). doi:10.1002/mop.70851

BibTeX
@article{Wang2026,
  author = {Wang, Wei and Duncan, Bradley and Bluem, Patrick and Beck, Devon and Rojas, Roberto and Chisum, Jonathan},
  title = {3D‐Printed Continuous Composite GRIN Media for Millimeter‐Wave Lenses in V‐ and W‐Band},
  journal = {Microwave and Optical Technology Letters},
  year = {2026},
  volume = {68},
  number = {11},
  doi = {10.1002/mop.70851}
}
Kostenlos starten →